DATA SHORT To request the full datasheet, please visit www.intersil.com/products/TW9960 FN7795 TW9960 Rev. 1.00 September 20, 2011 Low Power NTSC/PAL Video Decoder Supporting 960H Output Features Video Decoder Miscellaneous NTSC (M, 4.43) and PAL (B, D, G, H, I, M, N, N Two-wire MPU serial bus interface combination), PAL (60) support with automatic Power save and Power down mode format detection Low power consumption Software selectable analog inputs allow any of the Single 36MHz crystal for all standards following combinations, e.g. 2 CVBS or 1 Y/C 3.3V tolerant I/O Built-in analog anti-alias filter 1.8V/3.3 V power supply Two 10-bit ADCs and analog clamping circuit 32 pin TQFP package Fully programmable static gain or automatic gain control for the Y channel Programmable white peak control for the Y channel 4-H adaptive comb filter Y/C separation PAL delay line for color phase error correction Image enhancement with peaking and CTI Digital sub-carrier PLL for accurate color decoding Digital Horizontal PLL for synchronization processing and pixel sampling Advanced synchronization processing and sync detection for handling non-standard and weak signal Programmable hue, brightness, saturation, contrast, and sharpness Automatic color control and color killer Chroma IF compensation ITU-R 656 like YCbCr(4:2:2) output format Programmable output cropping FN7795 Rev. 1.00 Page 1 of 2 September 20, 2011 TW9960 Functional Description VD 7:0 CIN 0 U V MUX0 HSYNC MUX1 (1) Y VSYNC CLKX2 36 Mhz MPOUT PDN RSTB SCLK SDAT FIGURE 1. TW9960 BLOCK DIAGRAM Copyright Intersil Americas LLC 2011. All Rights Reserved. All trademarks and registered trademarks are the property of their respective owners. For additional products, see www.intersil.com/product tree Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted in the quality certifications found at