SF2431D High Performance SAW Filter 3.8 x 3.8 mm Surface-mount Package Complies with Directive 2002/95/EC (RoHS) Pb 505 MHz SAW Filter Absolute Maximum Ratings Rating Value Units Maximum Incident Power in Passband +10 dBm Maximum DC Voltage Between any Two Active Terminals 3 VDC Operable Temperature Range -45 to +125 C -40 to +85 C Specification Temperature Range Storage Temperature Range -40 to +95 C Suitable for Lead-free Soldering - Maximum Soldering Profile 260 C for 10 sec SM3838-8 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency f 505 MHz C Insertion Loss (500 to 510 MHz) ILmin 2.2 3.2 dB Amplitude Ripple (500 to 510 MHz) 0.8 1.5 Attenuation (Reference level from 0dB) 0 to 485 MHz 40 50 dB 555 to 800 MHz 45 50 Case Style 3.8 x 3.8 mm Nominal Footprint Lid Symbolization, Y=year, WW=week, S=shift, Dot=pin 1 indicator B41, YWWS Electrical Connections Connection Terminals Input 2 Output 6 Case Ground All others 1 8 7 50 50 2 6 3 4 5 CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating tem- 4.LRI or after the part number indicateslow rate initial productio perature range with filter soldered to the specified demonstration board andEN or indicatesengineering prototypes with impedance matching to 50 and measured with 50 network ana- 5. The design, manufacturing process, and specifications of this filter are lyzer. subject to change. 2. Unless noted otherwise, all frequency specifications are referenced to the 6. Either Port 1 or Port 2 may be used for either input or output in the design. nominal center frequency, fc. However, impedances and impedance matching may vary between Port 1 3. Rejection is measured as attenuation below the minimum IL point in the and Port 2, so that the filter must always be installed in one direction per passband. Rejection in final user application is dependent on PCB layout the circuit design. and external impedance matching design. See Application Note No. 42 7. US and international patents may apply. for details. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All rights reserved. 2016 SF2431D 8/31/17 Page 1 of 4 www.murata.comFrequency Characteristics Copyright Murata Manufacturing Co., Ltd. All rights reserved. 2016 www.murata.com SF2431D 8/31/17 Page 2 of 4