RRB-120

RoadRunner Electronic Products Page 1 of 1 High Density Eurocards: RRB-120 Select Product Double sided 3 plane. Double height eurocard - 233,4x220mm A 3 plane board with a copper pattern screen or ground plane marked GND on the component side. The wiring side pattern has two power rails marked VCC and GND and the screen may be connected to the GND rail by pinning. Specifications: DIN 41612 connector mounting holes at one end Material Blue epoxy glass Board thickness 1.6mm Can be used with Roadrunner, wire wrapping or discrete Connector pattern to DIN41612 component wiring Hole matrix 2.54 x 2.54mm Grid reference Hole size 1.02mm Copper Thickness 1oz/ft2 or 35 microns or 305g/m2 Roadrunner Electronic Products 2002 Roadrunner Electronic Products - Polyurethane Solderable Enamel Wire Material Saf... Page 1 of 1 MATERIAL SAFETY DATA SHEET PRODUCT: Polyurethane Solderable Enamel Wire APPLICATIONS Round copper wires used in the wiring of electronic circuits, windings of electrical motors, instruments and components. CHEMICAL AND PHYSICAL PROPERTIES Composition of resin: Modified Polyurethane Physical State: Solid Thermal Class: (IEC 172): 155 STORAGE AND HANDLING AND TRANSPORT Special transport precautions: None Special Storage precautions: None Personal protection measures: None INFLAMMABILITY AND EXPLOSION DANGER Not inflammable without primer With primer it is inflammable at temperature over 400C It is immediately auto-extinguishing It is not explosive TOXICOLIGICAL DATA In the case of total destruction by fire (by persistent flame at 700C) before auto-extinguishing, the product will exhale C0, C02, H20 as steam and will leave carbon residue. HAZARDOUS FUMES or DUST may be generated when soldering, welding, burning, wire brushing, melting or processing enameled wires. Excessive exposure to dust may cause irritation to the eyes, skin and/or respiratory systems. The wearing of appropriate protective eye, skin and breathing equipment may be required. Inhalation of fumes should be avoided. The soldering of polyurethane enamel can present an Isocyanate inhalation hazard. Levels of free Isocyanate above the control limit can be generated during the soldering operation. It is recognised that exposure to Isocyanates can lead to sensitisation and occupational Asthma. Fumes should be removed by efficient exhaust ventilation. EXPOSURE LIMITS Exposure limit 0.020mg per cubic metre for an 8 hour time weighted average reference period. Short term exposure limit 0.07mg per cubic metre for a 10 minute period. ECOLOGICAL DATA Waste should normally be recycled due to the high value of the base metal. It should be noted that enameled wires are lubricated with wax at < 75mg per square metre of wire surface. Roadrunner Electronic Products 2002