DATASHEET DC Filters FN2200 EMC/EMI Filter for PV Inverters Reduces conducted emissions towards the Approvals & Compliances solar panel Reduces the probability of EMI radiation off the solar panel Helps to prevent pre-mature panel aging because of HF leakage currents Helps to meet international EMC regulations for the entire PV system Most compact standard solution in the (cURus:600 VDC) (ENEC14: 600 VDC) industry, optionally available without capacitors to ground (B types) New: up to 2300 A FN 2200 are the most compact dedicated DC filters for PV inverters in the industry and therefore support the integration in shrinking frame sizes of power electronics. All FN 2200 come in unsymmetrical housings, which help to prevent inverse installation and wrong electrical connection. Along with grid- side installed AC EMC/EMI filters, FN 2200 are key to meet the international standards for electromagnetic Performance indicators compatibility (EMC) like EN 61000-6-3 and -6-4 and help to ensure a reliable and fault-free operation of the entire system. FN 2200 are designed for very low power loss, to support overall efficiency. Features and benefits FN 2200 range is based on experience in custom filter design for the photovoltaic (PV) inverter industry. Installed between the PV inverter and the solar panel, FN 2200 DC filters help to control conducted emissions on the panel side of the system and therefore significantly reduce the potential for high- frequency (HF) interference radiation off the panel. Technical specifications The filter also protects the solar panel from HF stray and leakage currents which can cause pre-mature Maximum continuous operating voltage Max. 1200 VDC aging in the PV modules. Operating frequency DC 25 to 2300 A 55C Rated currents Typical applications High potential test voltage P > E 3600 VDC for 2 sec P > P 3000 VDC for 2 sec FN 2200 are primarily designed for PV inverters. However, they can potentially also be used in other IP 20 (25 to 150 A types) IP 00 (250 to 2300 A types) Protection category DC applications within published specifications, like Overload capability 4x rated current at switch on, UPS, DC motor drives, or DC quick chargers. 1.5x rated current for 1 minute, once per hour Temperature range (operation and storage) -40C to +100C (40/100/21) UL 1283, CSA 22.2 No. 8 1986, IEC/EN 60939 Design corresponding to Typical electrical schematic FN2200 Flammability corresponding to UL 94 V-2 or better MTBF 55C/1200 V (Mil-HB-217F) min. 223,000 hoursTypical electrical schematic FN2200B