J-Link 19-Pin Cortex-M Adapter Segger Microcontroller

Embedded Software Solutions J-Link Adapters The following adapters are available for J-Link: J-Link JTAG Isolator The J-Link JTAG Isolator can be connected between J-Link and any ARM-board that uses the standard 20-pin JTAG-ARM connector to provide electricalisolation. This is essential when the development tools are not connected to the same ground as the application. It is also useful to protect the developmenttools from electrical spikes that often occur in some applications, such as motor control applications. Another typical field of application is development ofproducts with sensors or other analog circuitry, in which case the target hardware is protected from electrical noise originating from the development PC.This product is compatible with J-Link, J-Link Pro and Flasher ARM. J-Link RX Adapter The J-Link RX Adapter allows JTAG connections between J-Link and target hardware which comes with the Renesas RX600 series MCUs.The J- Link RX adapter is able to optionally power the connected target hardware.3.3V or 5V supply voltage can be selected using a Jumper. The target is supplied via the VTref connection when the supply option is jumpered. Embedded Software Solutions J-Link 19-pin Cortex-M Adapter The J-Link 9-pin Cortex-M Adapter allows JTAG, SWD and SWO connections between J-Link and Cortex- M based target hardware systems. It adapts from the 20-pin 0.1 JTAG connector to a 19-pin 0.05 Samtec FTSH connector as defined by ARM. The J-Link 19-pin Cortex-M Adapter may also be used to connect J-Link to a non Cortex-M target as far as the target connector uses the same pinout as shown below. By default, TRST is not connected, but the Cortex-M Adapter comes with a solder bridge (NR1) which allows TRST to be connected to pin 9 of the Cortex-M adapter. J-Link 9-pin Cortex-M Adapter The J-Link 9-pin Cortex-M Adapter allows JTAG, SWD and SWO connections between J-Link and Cortex- M based target hardware systems. It adapts from the 20-pin 0.1 JTAG connector to a 9-pin 0.05 Samtec FTSH connector as defined by ARM. The J-Link 9-pin Cortex-M Adapter may also be used to connect J-Link to a non Cortex-M target as far as the target connector uses the same pinout as shown below. By default, TRST is not connected, but the Cortex-M Adapter comes with a solder bridge (NR1) which allows TRST to be connected to pin 9 of the Cortex-M adapter.