DMO063 Sensata

PCB Mount DataSheet DMO Series Mini-SIP SSR Ratings to 3A 60 VDC MOSFET output DC control Low open output PRODUCT SELECTION Control Voltage 3 A 3-10 VDC DMO063 AVAILABLE OPTIONS Load Current 063: 3 Amps 063 DMO Series DMO: FET Output Required for valid part number For options only and not required for valid part number (1) OUTPUT SPECIFICATIONS Description DMO Operating Voltage Range (47-63Hz) VDC 0-60 Maximum Off-State Leakage Current Rated Voltage A 100 Maximum Load Current Adc 3.0 0 Minimum Load Current Adc Maximum Surge Current Adc 12 (10ms) Maximum On-State Voltage Drop Rated Current 0.4 (2) Minimum Power Factor (with Maximum Load) 0.5 (1) INPUT SPECIFICATIONS Description DMO063 Control Voltage Range 3-10 VDC Must Turn On Voltage 3.0 VDC Must Turn Off Voltage 1.0 VDC Typical Input Current 5 VDC 20 mAdc Nominal Input Impedance 270 Ohm Maximum Turn-On Time sec 50 Maximum Turn-Off Time sec 300 FDE-07-01 REV. A Do not forget to visit us at: www.crydom.com Copyright 2017 Crydom Inc. Specifications subject to change without notice.PCB Mount DataSheet GENERAL SPECIFICATIONS Parameters Description Dielectric Strength, Input/Output/Base (50/60Hz) (3) 2500 Vrms 9 Minimum Insulation Resistance ( 500 VDC) (3) 10 Ohm Maximum Capacitance, Input/Output 8 pF -30C to 80C Ambient Operating Temperature Range -30C to 125C Ambient Storage Temperature Range 0.15 oz. (4.3g) Weight (typical) Thermally Conductive Epoxy Encapsulation GENERAL NOTES 1) All parameters at 25C unless otherwise noted. 2) Typical On-State Resistance=0.13 ohms 3) Dielectric and insulation resistance are measured between input and output. 4) Inductive loads should be diode suppressed THERMAL DERATE INFORMATION 3 2 1 0 20 40 60 80 AMBIENT TEMPERATURE (C) DMO Max. Load Current vs.Temp MECHANICAL SPECIFICATIONS Tolerances: 0.02 in / 0.5 mm All dimensions are in: inches millimeters .95 Wiring Diagram (4) .20 (24.1) (5.1) + 1 LOAD +VDC 0.50 A (12.7) Load can be wired in position A or B LOAD CONTROL B -VDC 2 .25 LOAD (6.3) 1 2 3 4 CONTROL CIRCUIT + .10 3 +VDC (2.5) .03 .15 .50 (0.8) (0.4) (12.7) 4 -VDC .70 (17.8) AGENCY APPROVALS Agency Approvals Designed in accordance with the requirements of IEC 62314 Rev. 101317 ECN 20337 Do not forget to visit us at: www.crydom.com Copyright 2017 Crydom Inc. Specifications subject to change without notice. LOAD CURRENT (AMPS)