HSP-7 Sensata

Accessories Datasheet HSP-7 Thermal Pad suitable for NOVA22 Panel Mount SSRs Easy to use thermal interface material Excellent alternative to thermal grease TYPICAL PROPERTIES Description Parameters Material Chomerics T725 Color Pink Thickness inch (mm) 0.005 (0.127) Adhesive No Thermal Impedance C-in/W (1) 0.06 25 psi Thermal Conductivity W/m-K (1) 0.07 Flame Rating V0 Continuous Temperature Range C -55 to 125 Volume Resistivity Ohm-cm > 10 4 MOUNTING SURFACE PREPARATION The mounting surface, usually the heat sink, should be clean and free from machining oils and aluminum dust, and may be cleaned with any common solvent, such as isopropyl alcohol (IPA) if necessary. The surface of the heat sink may be anodized, chromate coated or unnished aluminum. INSTALLATION OF HSP-7 PADS HSP-7 material does not require pre-heating of the heat sink prior to installing the HSP-7 pad onto the heat sink, because of the phase change nature of the HSP-7 material, please follow the process temperature/pressure guidelines below to ensure the best results for a specic assembly process: Temperature/Pressure Process Step Recommended Range Removing pad from clear carrier liner Temp. of Roll: less than 38C (100F) Heat Sink Temp: 16C to 38C (60F to 100F) Installing pad onto cold heat sink Roll Temp: 21C to 38C (70F to 100F) Installation Pressure: 25 to 50 psi (2) Heat Sink Temp: 24C to 38C (75F to 100F) Installing pad onto warm heat sink Roll Temp: 21C to 38C (70F to 100F) Installation Pressure: 25 to 50 psi (2) Removing protective blue release liner Temp of Heat Sink/Pad Assembly: Less than 38C (100F) When removing the pull-tab, use a quick, lifting motion. This is preferable over peeling the pull-tab from the HSP-7 pad and heat sink. To ensure optimal wetting of the HSP-7 pad to the heat sink. It is recommended that the parts be allowed to dwell one hour prior to attempting release liner removal. Do not forget to visit us at: www.crydom.com Copyright 2016 Crydom Inc. Specifications subject to change without notice.Accessories Datasheet MECHANICAL SPECIFICATIONS Tolerances: 0.02 in / 0.5 mm All dimensions are in: inches Millimeters .67 17 1.55 39.4 .005 0.1 GENERAL NOTES (1) This value is provided for reference only. Follow installation instructions for accurate thermal performance. (2) Apply pressure to the HSP-7 pad with a soft press-pad for 2 to 3 seconds. Rev. 100615 Do not forget to visit us at: www.crydom.com Copyright 2016 Crydom Inc. Specifications subject to change without notice.