VZ120Q-STK

Calliope VZ120Q Module Starter Kit Calliope VZ120Q Module - Starter Kit This Starter Kit enables out-of-the-box testing of Sequans Calliope VZ120Q module connectivity on Verizon Wireless LTE network or testing equipment . It supports integration of the module with a host platform through a USB interface. Connect the Starter Kit to your Windows laptops USB port and begin your tests by using its rich set of AT commands. Getting started Install Starter Kit driver using a Windows laptop. Driver installer available here: www.sequans.com/vz120q-stk Screw the SMA antenna on to the Starter Kit with an SMA connector and insert a Micro SIM card (2FF) from your network provider into the SIM slot Connect the Starter Kit to your host through the USB interface using the provided male-male USB cable Content The Starter Kit hosting the The Starter Kit will connect automatically to your LTE network Calliope VZ120Q module USB cable to connect to the Full Starter Kit documentation is available for download at host PC www.sequans.com/vz120q-stk Two antennas sequans.comCalliope VZ120Q Module Starter Kit Calliope VZ120Q module block diagram POWER SUPPLIES ANT 1 Serial LPDDR 32kHz XO Flash PMIC USB 2.0 ANT 2 RF Front End Sequans Sequans SQN3241 SQN3223 Band 13 RF Transceiver LTE Baseband SDIO 3.0 Band 4 TCXO SPI/I2C HS UART PCM/I2S VZ120Q Module characteristics Data Interfaces LTE modem USB 2.0 device Certi ed compliant with Verizon Open Network speci cations SDIO3.0 host 20x21x1.5mm, LGA module SPI Operates on FDD LTE bands 4 and 13 High speed UART 3GPP Release 10 and GCF compliant PCM-TDM and I2S (audio) VoLTE ready Certi ed compliant with FCC modular requirements Environmental Max transmit power up to +23 dBm Operating temperature: -30 C to +60 C ambient RoHS Compliant Storage: -40 C to +85 C Throughput LTE Category 1: 10 Mbps DL / 5 Mbps UL Sequans and Calliope are trademarks or registered trademarks of Sequans Communications. LTE is a trademark of ETSI. Copyright 2020 PI-VZ120Q Module STK-3-20200615