EM358x High-Performance, Integrated ZigBee/802.15.4 System-on-Chip Family Complete System-on-Chip Exceptional RF Performance - 32-bit ARM Cortex -M3 processor - Normal mode link budget up to 103 dB configurable up to 110 dB - 2.4 GHz IEEE 802.15.4-2003 transceiver & lower MAC - 100 dBm normal RX sensitivity configurable to - 256 or 512 kB flash, with optional read protection 102 dBm (1% PER, 20 byte packet) - 32 or 64 kB RAM memory - +3 dB normal mode output power configurable up to - AES128 encryption accelerator +8 dBm - Flexible ADC, UART/SPI/TWI serial communications, - Robust Wi-Fi and Bluetooth coexistence and general purpose timers - Optional USB serial communications Innovative network and processor debug - 24 highly configurable GPIOs with Schmitt trigger inputs - Packet Trace Port for non-intrusive packet trace with Ember development tools Industry-leading ARM Cortex -M3 processor - Serial Wire/JTAG interface - Leading 32-bit processing performance - Standard ARM debug capabilities: Flash Patch & Break- - Highly efficient Thumb-2 instruction set point Data Watchpoint & Trace Instrumentation Trace - Operation at 6, 12, or 24 MHz Macrocell - Flexible Nested Vectored Interrupt Controller Application Flexibility Low power consumption, advanced management - Single voltage operation: 2.13.6 V with internal 1.8 and - RX Current (w/ CPU): 27 mA 1.25 V regulators - TX Current (w/ CPU, +3 dBm TX): 31 mA - Optional 32.768 kHz crystal for higher timer accuracy - Low deep sleep current, with retained RAM and GPIO: - Low external component count with single 24 MHz 1.0 A without/1.25 A with sleep timer crystal - Low-frequency internal RC oscillator for low-power sleep - Support for external power amplifier timing - Small 7x7 mm 48-pin QFN package - High-frequency internal RC oscillator for fast (110 s) processor start-up from sleep TX ACTIVE Data Program PAselect RAM Flash RF TX ALT P,N PA 64 kB 512 kB SYNTH DAC MAC PA + nd Baseband TM ARM Cortex -M3 2 level RF P,N LNA IF ADC CPU with NVIC Interrupt and MPU controller PacketTrace Bias CPU debug Encryption OSCA TPIU/ITM/FPB/ HFcrystal Internal HF Calibration acclerator DWT/ETM ADC OSC RC-OSC General OSCB purpose Always 1.25V timers VDD CORE Powered Regulator USB Serial SWCLK,JTCK Domain Device Wire and 1.8V GPIO VREG OUT JTAG Regulator registers Watchdog debug General Purpose nRESET POR ADC UART/ SPI/TWI Chip Sleep LFcrystal Internal LF manager timer OSC RC-OSC GPIO multiplexor switch PA 7:0 , PB 7:0 , PC 7:0 Rev 1.0 4/14 Copyright 2014 by Silicon Laboratories EM358xEM358x General Description The Ember EM358x is a fully integrated System-on-Chip that integrates a 2.4 GHz, IEEE 802.15.4-2003-compliant TM transceiver, 32-bit ARM Cortex -M3 microprocessor, flash and RAM memory, and peripherals of use to designers of ZigBee-based systems. The transceiver uses an efficient architecture that exceeds the dynamic range requirements imposed by the IEEE 802.15.4-2003 standard by over 15 dB. The integrated receive channel filtering allows for robust co-existence with other communication standards in the 2.4 GHz spectrum, such as IEEE 802.11-2007 and Bluetooth. The integrated regulator, VCO, loop filter, and power amplifier keep the external component count low. An optional high performance radio mode (boost mode) is software-selectable to boost dynamic range. TM The integrated 32-bit ARM Cortex -M3 microprocessor is highly optimized for high performance, low power consumption, and efficient memory utilization. Including an integrated MPU, it supports two different modes of operationprivileged mode and user mode. This architecture could allow for separation of the networking stack from the application code, and prevents unwanted modification of restricted areas of memory and registers resulting in increased stability and reliability of deployed solutions. The EM358x has either 256 or 512 kB of embedded flash memory and either 32 or 64 kB of integrated RAM for data and program storage. The Ember software for the EM358x employs an effective wear-leveling algorithm that optimizes the lifetime of the embedded flash. To maintain the strict timing requirements imposed by the ZigBee and IEEE 802.15.4-2003 standards, the EM358x integrates a number of MAC functions, AES128 encryption accelerator, and automatic CRC handling into the hardware. The MAC hardware handles automatic ACK transmission and reception, automatic backoff delay, and clear channel assessment for transmission, as well as automatic filtering of received packets. The Ember Packet Trace Interface is also integrated with the MAC, allowing complete, non-intrusive capture of all packets to and from the EM358x with Ember development tools. The EM358x offers a number of advanced power management features that enable long battery life. A high- frequency internal RC oscillator allows the processor core to begin code execution quickly upon waking. Various deep sleep modes are available with less than 2 A power consumption while retaining RAM contents. To support user-defined applications, on-chip peripherals include optional USB, UART, SPI, TWI, ADC, and general-purpose timers, as well as up to 24 GPIOs. Additionally, an integrated voltage regulator, power-on-reset circuit, and sleep timer are available. Finally, the EM358x utilizes standard Serial Wire and JTAG interfaces for powerful software debugging and TM programming of the ARM Cortex -M3 core. The EM358x integrates the standard ARM system debug components: Flash Patch and Breakpoint (FPB), Data Watchpoint and Trace (DWT), and Instrumentation Trace Macrocell (ITM) as well as the advanced Embedded Trace Macrocell (ETM). Target applications for the EM358x include: Smart Energy Building automation and control Home automation and control Security and monitoring General ZigBee wireless sensor networking This technical data sheet details the EM358x features available to customers using it with Ember software. 2 Rev 1.0