ST7538QTR STMicroelectronics

ST7538Q FSK power line transceiver General features Half duplex frequency shift keying (FSK) transceiver Integrated power line driver with programmable voltage and current control Programmable interface: Synchronous TQFP44 Slug Down Asynchronous Single supply voltage (from 7.5 up to 12.5V) Very low power consumption (Iq = 5mA) Description Integrated 5V voltage regulator (up to 50mA) The ST7538Q is a Half Duplex with short circuit protection synchronous/asynchronous FSK Modem Integrated 3.3V voltage regulator (up to 50mA) designed for power line communication network with short circuit protection applications. It operates from a single supply 3.3V or 5V digital supply voltage and integrates a line driver and two linear regulators for 5V and 3.3V. The device operation 8 programmable transmission frequencies is controlled by means of an internal register, Programmable baud rate up to 4800BPS programmable through the synchronous serial Receiving sensitivity up to 250Vrms interface. Additional functions as watchdog, clock output, output voltage and current control, Suitable to application in accordance with EN preamble detection, time-out, band in use are 50065 CENELEC specifications included. Realized in Multipower BCD5 Carrier or preamble detection technology that allows to integrate DMOS, Bipolar Band in use detection and CMOS structures in the same chip. Programmable 24 or 48 bit register with security checksum Mains zero crossing detection and synchronization Watchdog timer Output voltage freeze 8 or 16 bit header recognition UART/SPI host interface ST7537 compatible Order codes Part number Package Packaging ST7538Q TQFP44 Slug Down Tube ST7538QTR TQFP44 Slug Down Tape and reel July 2006 Rev 1 1/44 www.st.com 44Contents ST7538Q Contents 1 Block diagram 4 2 Pin settings 5 2.1 Pin connection 5 2.2 Pin description 6 3 Electrical data 8 3.1 Maximum ratings 8 3.2 Thermal data . 9 4 Electrical characteristics . 9 5 Functional description 15 5.1 Carrier frequencies 15 5.2 Baud rates 15 5.3 Mark and space frequencies 16 5.4 ST7538Q mains access 17 5.5 Host processor interface . 18 5.5.1 Communication between host and ST7538Q 20 5.6 Control register access . 21 5.7 Receiving mode 23 5.7.1 High sensitivity mode . 23 5.7.2 Synchronization recovery system (PLL) 23 5.7.3 Carrier/preamble detection 24 5.7.4 Header recognition 24 5.8 Transmission mode . 26 5.8.1 Automatic Level Control (ALC) 27 5.9 Crystal oscillator 30 5.10 Control register . 31 5.11 Detection method and Rx Sensitivity in UART mode 35 2/44