STEVAL-MKI080V1 STMicroelectronics

UM0855 User manual Demonstration kit for single and double axis gyroscopes in a 4 x 5 mm package Introduction This document applies to all demonstration kits related to ST MEMS single and double axis gyroscopes in 4 x 5 mm packages, hereafter referred to as STEVAL-MKI0xxV1. The STEVAL-MKI0xxV1 is a demonstration kit designed to provide the user with a complete, ready-to-use platform for demonstration of the LPR4xxAL and LPR4xxxAL product families. The device includes a sensing element and an IC interface capable of translating information from the sensing element into a measured signal that can be used for external applications. In addition to the MEMS sensor, the demonstration board utilizes an ST72651AR6 microcontroller which functions as a bridge between the sensor and the PC, on which it is possible to use the downloadable graphical user interface (GUI), or dedicated software routines for customized applications. This user manual describes the hardware included with the demonstration kit and provides the information required to install and run the demonstration kit user interface. For details regarding the features of each member of the LPR4xxAL and LPR4xxxAL sensor families, please refer to the datasheets available for each single device. November 2009 Doc ID 16617 Rev 1 1/35 www.st.comContents UM0855 Contents 1 Demonstration kit description . 5 2 Working modes . 7 2.1 Analog working mode (AWM) . 7 2.2 Digital working mode (DWM) . 8 2.3 Additional settings . 9 3 STEVAL-MKI0xxV1 GUI installation 10 3.1 PC system requirements . 10 3.2 Software installation . 10 3.3 Hardware installation 11 4 Graphical user interface . 14 4.1 Connecting to the virtual COM port . 15 4.2 GUI main window functions . 15 4.2.1 Easy Start button . 15 4.2.2 Home tab . 16 4.2.3 Options tab . 16 4.2.4 Bars tab 17 4.2.5 Plot tab 18 4.2.6 Data tab 20 4.2.7 FFT tab 21 5 Data acquisition quick start 22 6 STEVAL-MKI0xxV1 Lite 23 7 Supported commands 24 7.1 Getting started . 24 7.2 Supported commands . 24 7.2.1 Start command (DWM only) . 25 7.2.2 Debug command (DWM only) 25 7.2.3 Stop command (DWM only) 26 7.2.4 Zon and Zoff . 26 2/35 Doc ID 16617 Rev 1