TC75S56F/FU TOSHIBA CMOS Linear Integrated Circuit Silicon Monolithic TC75S56F, TC75S56FU Single Comparator TC75S56F The TC75S56F/TC75S56FU is a CMOS general- purpose single comparator. The device can operate off a single power supply and draws a lower supply current than a conventional bipolar general- purpose comparator. This devices push-pull output stage can be directly connected to TTL or CMOS logic ICs, among others. Features (SMV) Low-current power supply : I = 10 A (typ.) DD TC75S56FU Single power supply operation : VDD = 0.9 to 3.5 V or 1.8 to 7 V Wide common mode input voltage range : V to V 0.9 V SS DD Push-pull output circuit Low input bias current Small package (USV) Weight SSOP5-P-0.95 : 0.014 g (typ.) SSOP5-P-0.65A : 0.006 g (typ.) Marking (top view) Pin Connection (top view) V OUT 5 4 DD 5 4 T C 1 2 3 IN () V IN (+) SS 1 2 3 Start of commercial production 1996-11 2019 2019-09-11 1 Toshiba Electronic Devices & Storage Corporation TC75S56F/FU Absolute Maximum Ratings (Ta = 25C) Characteristics Symbol Rating Unit Supply voltage V , V 3.5 or 7 V DD SS Differential input voltage DV 7 V IN Input voltage VIN VSS to VDD V Output Current I 35 mA OUT Power dissipation P 200 mW D Operating temperature T 40 to 85 C opr Storage temperature T 55 to 125 C stg Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (Handling Precautions/Derating Concept and Methods) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note: This devices CMOS structure makes it prone to latch-up. To prevent latch-up, please take the following precautions: Ensure that no I/O pins voltage level ever exceeds VDD or drops below VSS. In addition, check the power-on timing. Do not subject the device to excessive noise. 2019 2019-09-11 2 Toshiba Electronic Devices & Storage Corporation