TLP2703 Photocouplers Infrared LED & Photo IC TLP2703TLP2703TLP2703TLP2703 1. 1. ApplicationsApplications 1. 1. ApplicationsApplications Communications Equipment Industrial Inverters Home Electric Appliances 2. 2. 2. 2. GeneralGeneralGeneralGeneral The Toshiba TLP2703 consists of a high-output infrared LED coupled with a high-speed photodiode transistor chip. It is housed in a thin SO6L package with a thickness of 2.3 mm (max). The TLP2703 guarantees an isolation voltage of 5 kVrms (min) and is compliant with international safety standards for reinforced insulation. Due to the use of a high-speed, high-gain detector element, the TLP2703 provides a current transfer ratio of 900 % ( I = 0.5 mA) minimum over -40 to 125 and thus is ideal for applications which require low input F current and high-speed data transmission. The TLP2703 supports a data rate of 100 kbps, and fills a gap in our product line between general-purpose transistor-output photocouplers and IC-output photocouplers with a data rate of 1 Mbps. 3. 3. FeaturesFeatures 3. 3. FeaturesFeatures (1) Package: SO6L (2) Operating temperature: -40 to 125 (3) Current transfer ratio: 900 % (min) I = 0.5 mA F (4) Maximum output current: 80 mA (5) Propagation delay time: t = 15 s (max), t = 50 s (max) R = 4.7 k, I = 0.5 mA, T = 25 pHL pLH L F a (6) Isolation voltage: 5000 Vrms (min) (7) Safety standards UL-recognized: UL 1577, File No.E67349 cUL-recognized: CSA Component Acceptance Service No.5A File No.E67349 (Note 1) VDE-approved: EN 60747-5-5, EN 62368-1 (Note 1)(Note 1)(Note 1) CQC-approved: GB4943.1, GB8898 Japan and Thailand Factory Option (D4) Note 1: When a VDE approved type is needed, please designate the Option (D4)Option (D4)Option (D4). Start of commercial production 2014-06 2015-2019 2019-11-29 1 Toshiba Electronic Devices & Storage Corporation Rev.6.0TLP2703 4. 4. 4. 4. Packaging and Pin AssignmentPackaging and Pin AssignmentPackaging and Pin AssignmentPackaging and Pin Assignment 1: Anode 2: N.C. 3: Cathode 4: GND (Emitter) 5: Output (Collector) 6: V CC 11-4N1A 5. 5. Internal Circuit (Note)Internal Circuit (Note) 5. 5. Internal Circuit (Note)Internal Circuit (Note) Note: A 0.1-F bypass capacitor must be connected between pin 6 and pin 4. 6. Principle of Operation 6. 6. 6. Principle of OperationPrinciple of OperationPrinciple of Operation 6.1. 6.1. 6.1. 6.1. Truth TableTruth TableTruth TableTruth Table Input LED Output H ON L L OFF H 6.2. Mechanical Parameters 6.2. 6.2. 6.2. Mechanical ParametersMechanical ParametersMechanical Parameters Characteristics Dimension Unit Package height 2.3 (max) mm Creepage distances 8.0 (min) Clearance distances 8.0 (min) Internal isolation thickness 0.4 (min) 2015-2019 2019-11-29 2 Toshiba Electronic Devices & Storage Corporation Rev.6.0