Photologic Sensor OPL530, OPL531, OPL535, OPL536, OPL550, OPL551, OPL560, OPL561, OPL562, OPL563 Features: Choice of four output options in low -cost side-looking package Choice of two sensitivity opons (OPL5ti 60/561/562/563) High noise immunity Direct TTL/LSTTL CMOS interface Data rates to 250 kBaud for all except OPL560 series (200 kBaud) Low power consumption Ro HS Description: All components in this series include a photodiode, amplifier, voltage regulator, Schmitt trigger and NPN output transistor o n a single silicon chip. OPL560 chips also include a voltage regulator on the chip. All devices in the series have a Photologic chip that is encapsulated in a molded plastic side -looking package with an integral lens (recessed integral lens for OPL535 and OPL536). This packaging provides enhanced optical coupling, combined with mechanical protection. The hysteresis characteristics of the Sch mitt trigger on each device offers high immunity to noise on input and V . CC OPL530, OPL531, OPL535 and OPL536 include a 10 K pull-up resistor (R ) from output to V . These components exhibit very stable L CC performance over supply voltages ranging from 4.5 V to 16 V and a wide range of irradiance levels. OPL550 and OPL551 devices feature TTL/LSTTL compatible logic level output which can drive up to 8 TTL loads without additional circuitry and medium -speed data rates to 250 kBaud, with typical rise and fall times of 25 nanoseconds. OPL560, OPL561, OPL562 and OPL563 devices feature TTL/LSTTL compatible logic level output which can drive up to 10 TTL loads over supply voltages ranging from 4.5 V to 16 V. OPL530, OPL531, OPL550, OPL551, OPL560, OPL561, OPL562 and OPL563 are mechanically and spectrally matched to OP140 and OP240 LEDs. OPL535 and OPL536 are mechanically and spectrally matched to OP145 and OP245 series LEDs. Applications: Non-contact reflective object sensor Assembly line automation Machine automation Machine safety End of travel sensor Door sensor Input Power Range 2 (mW/cm ) Min/Max Base Part Number Package Output Type - with Light - A B OPL530, OPL530-OC Internal 10K - High External Lens OPL531A, OPL531-OCA Internal 10K - Low 0.08/0.40 0.08/0.25 0.20/0.40 OPL535A, OPL535B Internal 10K - High Recessed Lens OPL536A, OPL536-OC, OPL536-OCA Internal 10K - Low OPL550, OPL550A, OPL550-OC, OPL550-OCA Totem Pole - High 0.25/2.4 0.25/1.4 N/A OPL551A, OPL551-OC, OPL551-OCA Totem Pole - Low 0.25/2.5 0.25/1.5 OPL560, OPL560A, OPL560-OCA Totem Pole - High External Lens 0.09/0.55 0.09/0.36 N/A OPL561, OPL561-OC, OPL561-OCA Totem Pole - Low OPL562, OPL562A, OPL562-OC, OPL562-OCA Totem Pole - High 0.025/0.23 0.025/0.14 N/A OPL563, OPL563-OC, OPL563-OCA Totem Pole - Low OC = Open Collector Output General Note TT Electronics OPTEK Technology TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006 Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics own data and is www.ttelectronics.com sensors ttelectronics.com considered accurate at time of going to print. Rev G 11/2019 Page 1 TT electronics plc Form 500-1080-001 Rev - 06/2019 Photologic Sensor OPL530, OPL531, OPL535, OPL536, OPL550, OPL551, OPL560, OPL561, OPL562, OPL563 OPL530, OPL550, OPL560 Series MILLIMETERS DIMENSIONS ARE IN: INCHES Pin Sensor 1 Ground Pin Sensor 2 Output 1 Ground 3 V CC 2 Output 3 Vcc OPL535, OPL536 Series MILLIMETERS DIMENSIONS ARE IN: INCHES Pin Sensor Pin Sensor 1 Ground 1 Ground 2 Output 3 V CC 2 Output 3 Vcc General Note TT Electronics OPTEK Technology TT Electronics reserves the right to make changes in product specification without 1645 Wallace Drive, Carrollton, TX 75006 Ph: +1 972 323 2200 notice or liability. All information is subject to TT Electronics own data and is www.ttelectronics.com sensors ttelectronics.com considered accurate at time of going to print. Rev G 11/2019 Page 2 TT electronics plc Form 500-1080-001 Rev - 06/2019