Magnetic field sensor For Detection of Ferromagnetic Parts NIMFE-M12/4.6L88-UP6X-H1141 Threaded barrel, M12/M8 Chrome-plated brass DC 3-wire, 1030 VDC NC/NO parametrizable with teach adapter VB2-SP1 M12 x 1 male connector Wiring Diagram Type designation NIMFE-M12/4.6L88-UP6X-H1141 Ident no. 1600608 The weld sensors are available in different versions, with different signal intensities and Ambient temperature -25+70 C diameters. Ferromagnetic parts which differ strongly in their material properties and di- Operating voltage 1030 VDC ameters can thus be detected. A target part Residual ripple 10 % U ss has to be located within the so called sensi- DC rated operational current 200 mA tive area in order to be detected. The internal No-load current I 0 15 mA sensor signal reaches the maximum intensity Residual current 0.1 mA if the sensitive area is completely covered by Isolation test voltage 0.5 kV Short-circuit protection yes/ Cyclic the target. Partial coverage is also possible. Voltage drop at Ie 1 V Sensitive area S = 9 mm Wire breakage/Reverse polarity protection yes/ Complete Within this area the sensor signal changes Output function 3-wire, Connection programmable, PNP when components are connected. Design Threaded barrel, M12 1 Maximum range M = 13 mm Dimensions 88 mm In case of complete coverage of the sen- Housing material Metal, CuZn, Chrome-plated sitive area the maximum signal intensity is Active area material Metal, CuZn, chrome-plated achieved. Max. tightening torque housing nut 10 Nm Electrical connection Connector, M12 1 Vibration resistance 55 Hz (1 mm) Shock resistance 30 g (11 ms) Protection class IP67 MTTF 874 years acc. to SN 29500 (Ed. 99) 40 C Power-on indication LED green Switching state LED yellow 1 / 4 Hans Turck GmbH & Co.KG D-45472 Mlheim an der Ruhr Witzlebenstrae 7 Tel. 0208 4952-0 Fax 0208 4952-264 more turck.com www.turck.com Edition 2017-09-20T12:11:05+02:00Magnetic field sensor For Detection of Ferromagnetic Parts NIMFE-M12/4.6L88-UP6X-H1141 examples of use The magnetic field sensor is espcially suited for the de- tection of welding nuts as well as spacer or reinforcing sleeves. The parts have to be made of ferromagnet- ic material in order to guarantee correct performance. Most applications need center bolts to retain the weld- ing nuts and reinforcing sleeves and thus provide me- chanical protection of the sensors. Theses bolts have to be made of non-ferromagnetic material, like stainless steel for example. Center bolts are not available at Tur- ck, as these have to be produced individually and ad- justed to the correspondent application. The weld sensor detects targets with diameters be- tween 10 and 12mm easily. 2 / 4 Hans Turck GmbH & Co.KG D-45472 Mlheim an der Ruhr Witzlebenstrae 7 Tel. 0208 4952-0 Fax 0208 4952-264 more turck.com www.turck.com Edition 2017-09-20T12:11:05+02:00