Ground cord used to connect mats to (Earth Bonding Point) plugs 6 1 megohm (1x10 ohms) resistor in socket end 2.5mm cord diameter Several lengths available PVC insulation with 7 ends duplex tinsel copper conductor Item Description VER-26968 CORD,STRAIGHT,1.5M,10MMSOCKET/ M5 RING TERMINAL EPA ground cords shall be used to make electrical connections between groundable points and the EPA ground facility. Where a single resistor is used in the EPA ground cord, this shall be located near the groundable point. Where more than one resistor is used, a resistor of a minimum resistance value of one half the total resistance shall be located near the groundable point. When accessible, the EPA ground cord and its groundable point connection shall be Unless otherwise noted, tolerance is 10% Made in the shrouded by insulating material. (EN 61340-5-1 section 5.3.4 EPA ground cords) United Kingdom Specifications and procedures subject to change without notice. Straight Cord, 10mm Socket, M5 Ring Terminal VERMASON DATE: UNIT C, 4TH DIMENSION, FOURTH AVENUE, LETCHWORTH, Drawing Number HERTS, SG6 2TD UK September PHONE: +44 (0) 1462-672005, FAX: +44 (0) 1462-670440 VER-26968 2015 E-MAIL:Service Vermason.co.uk, INTERNET: Vermason.co.uk 2015 VERMASON.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Vermason manufacturer: Other Similar products are found below : 072425B 229765 200535 222547 222562 50424 229625 242296 210320 210300 35268 220522 242140 47200 231250 203065 237670 231288 242210 242278 242291 239260 222635 237195 203005 241090 229100 242276 230310 J6609 242271 47201 242274 230480 238711 200520 35594 35595 230660 230500 237675 211045 231275 229775 237200 229755 203015 229630 230260 200515