280-675 Wago

Network Rail Approved WAGO Terminal Replacement for the 2BA Stud Terminal Block PI 04-11-12Product Information WAGO Part No. 280-675 TS35 DIN rail-mounted terminal block with disconnect link facility H 800V/8kV/3, 24A 0.08 - 2.5mm L Terminal block width 5mm Insulation stripping length: 8-9mm Length 93mm Height 28mm Height with disconnect jumper 44mm Width 5mm Red Insulation stop (part number 280-498) is available as an equivalent to the red dome nut and can be fitted into the jumper location once the disconnect link has been removed. Installation and removal of this part can be seen on the Operating Information page in Part 2. The 280-498 is based on the existing white disconnect link. However this new part only has one leg which is used for holding the stop in place. Its purpose is solely to blank off the centre jumper locations. The 231-126/011-000 is a test probe that can be used in the screwdriver entry point. This device is inserted in the same way as a screwdriver, by angling its entry into the terminal block. It is pushed down the back of the clamp making contact with the busbar and clamp simultaneously.