DPC70US12 XP Power

AC-DC Power Supplies DPC70 Series 70 Watts Ultra Slim Design xxx Series Ambient Operation from -25 C to +70 C High Efficiency Wide Output Adjustment Range 12 V to 48 V Nominal Outputs <0.5 W No Load Input Power 3 Year Warranty GREEN POWER Dimensions: DPC70: 3.6 x 1.59 x 3.94 (90.0 x 40.5 x100.0 mm) Models & Ratings (2) (1) Output Voltage Output Power Output Voltage Trim Output Current Typical Efficiency Model Number 12 V 66 W 11.4-15.6 V 5.5 A 88% DPC70US12 24 V 72 W 22.5-28.5 V 3.0 A 89% DPC70US24 48 V 72 W 47.0-52.8 V 1.5 A 89% DPC70US48 Notes 1. Typical efficiency at 230 VAC and full load. 2. Output current should be limited so that nominal output power is not exceeded. Mechanical Details 1.59 (40.5) 3.94 (100.0) -V -V +V +V VOUT ADJ. ON 3.60 (90.0) DPC70 xppower.com N L Notes 1. All dimensions in inches (mm) 4. Screw terminal: 12-26 AWG cables size. 2. Weight: 0.51 lbs (230 g) 5. Connection screw maximum torque: 5.0 lbs-in (0.56 Nm) 3. Tolerance: 0.02 in (0.5 mm) www.xppower.com 1AC-DC Power Supplies DPC70 Series Input Characteristic Minimum Typical Maximum Units Notes & Conditions Input Voltage - Operating 85 264 VAC See input voltage derating curve Input Frequency 47 50/60 63 Hz Power Factor Conforms to EN61000-3-2 Class A Input Current - Full Load 1.45/0.8 A 115/230 VAC Inrush Current 30/60 A At 115/230 VAC Earth Leakage Current 1 mA At 264 VAC, 60 Hz Input Protection T3.15 A / 250 V internal in-line fuse No Load Input Power 0.5 W Output Characteristic Minimum Typical Maximum Units Notes & Conditions Output Voltage - V1 12 48 VDC See Models and Ratings table Initial Set Accuracy 0 +1 % At 100% load See Models and Ratings table, output power rating must Output Voltage Adjustment % not be exceeded Minimum Load 0 A No minimum load required Capacitive Load 3500/1000 F 12 V & 24 V Output/48 V Output Start Up Delay 2.5 s Start Up Rise Time 150 ms Hold Up Time 15/50 ms At full load and 115 VAC/230 VAC Line Regulation 1 % Load Regulation 1 % Recovery within 1% in less than 2 ms Transient Response - V1 4 % for a 50% step load change at 0.2 A/ s Ripple & Noise 100 mV pk-pk Measured at 20 MHz bandwidth 16.2 18.0 12 V model 28.8 32.4 24 V model Overvoltage Protection V 57.6 62.4 48 V model Overload Protection 150 % Short Circuit Protection Trip and Restart (Hiccup Mode) Temperature Coefficient 0.03 %/C General Characteristic Minimum Typical Maximum Units Notes & Conditions Efficiency 87 % See Models & Ratings table 3000 VAC Isolation: Input to Output Input to Ground 1500 VAC Output to Ground 500 VAC Switching Frequency 40 100 kHz Output LED Green LED to indicate output on. Mean Time Between Failure 550 kHrs BELLCORE issue 6 at 40 C, GB Weight 0.51 (230.0) lb (g) www.xppower.com 2