Digital Vane Sensor VN1015 Sensors Magnetically activated digital vane sensor in a rugged, overmolded plastic housing with three pins or 3-wire flying leads Description The VN1015 sensors employ a Hall Effect digital vane sensor and a permanent magnet in two small towers, separated by a 3.4 mm (0.135) air gap. The output switches when a ferrous target passes between the towers. Typical targets are linear or rotary vanes using a square saw tooth or an open slot in a solid disk or band. Features Typical Applications Mechanically interchangeable with typical slotted optical switches Door/gate position control Robust, high speed sensing in dirty/dusty environments Exercise equipment No mechanical contacts to wear out Printers Open collector (sinking or NPN) output can be used with bipolar or CMOS logic circuits with suitable pull-up resistor RoHS compliant Environmental Specifications Operating Temperature (VN101501, VN101503) -40 C to 85 C (-40 F to 185 F) Operating Temperature (VN101502, VN101504) -40 C to 150 C (-40 F to 302 F) Storage Temperature (VN101501, VN101503) -40 C to 85 C (-40 F to 185 F) Storage Temperature (VN101502, VN101504) -40 C to 150 C (-40 F to 302 F) Electrical Specifications Supply Voltage 3.8 to 24 VDC Maximum Input Voltage 30 VDC Maximum Reverse Voltage 30 VDC Supply Current 4.1 mA typ., 7.5 mA max. Output (Sink) Current 25 mA max. Recommended Pull-Up Resistor See Chart Mechanical Specifications Housing Material Over-molded plastic Sensor Orientation Sensitive see drawing Recommended Vane Parameters Low carbon material at least 10.16 mm (0.04 ) thick, should penetrate to a depth < 3.05 mm (0.12 ) from bottom of sensor slot Part Number Termination VN101501 pins VN101502* pins VN101503 24 AWG x 150 mm leads VN101504* 24 AWG x 150 mm leads *Not commonly stocked Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. www.cherryswitches.com Page 1 of 2, last update 2014-10-16, Specifications subject to change without notice. Recommended External Pull-Up Resistor Volts DC 5 9 12 15 24 Ohms 1k 1.8k 2.4k 3k 3k Open Collector Sinking Block Diagram Dimensions mm (inches) www.cherryswitches.com Page 2 of 2, last update 2014-10-16, Specifications subject to change without notice.