AC-25CD1.25APME

Constant Current LED Driver Model Number AC-25CD1.25APME Input Voltage: 120-277V Input Frequency: 50/60Hz Programmable, Digital, Wide-Range Side Mount/Leads Options Ajustable Current & Dimming < 1 Sec. Start time/(batch code AKT.48) Class P Listed Dim-to-1% (Default) Max Current ELECTRICAL SPECIFICATIONS: Min PF T Min Output Input Input Max THD Output Output IP Efcifi ency Dimming Dimming (full case Starting Power Power Current (full load) Voltage Current Rating Up To Protocol Range load) Max Temp** 0.27A 120V 15 to 350 to 1 to 0 to 10V 25W 31W >0.95 <20% 90C -40C 64 82% 100% 0.11A 277V 55V 1250mA ** This driver can operate down to -40C in a non-dimming PHYSICAL: condition. Below 0C some flicker may be observed. Hot Spot WIRING: Dimensions Length Width Height Mounting AC-25CD1.25APME 5.23 2.48 1.18 4.84 Tref Max Value (C) Tc/Tref Value (C) Ta/Value (C) Lead Lengths 90 58.2 40 Black 5.9 Blue 5.9 Purple 7.1 White 5.9 Red 5.9 Gray 7.1 SAFETY: Class P Listed LED driver has a life expectancy of FCC Title 47 CFR Part 15 Class A sound rating 100,000 hours at Tcase of 65C Surge Protection (2 KV) Overload Protection Warranty: 5 yrs based on max case temp Open/Short Circuit Protection of <75C 3 yrs based on max case temp Dim-To-Off Programming Option LED driver has a life expectancy of of 90C* o Active: Code = 4C 04 01 02 50,000 hours at Tcase of 75C Input/Output Isolation o Inactive: Code = 4C 04 00 02 INSTALLATION: LED drivers shall be installed inside electrical enclosures Max Remote installation distance is 18 ft 18 AWG 600V/105C tinned stranded copper lead-wires are required for LED driver cases should be grounded installation *AC Electronics/AC LED Power Designs warrants to the purchaser that each LED Driver will be free from defects in material or workmanship for a period of 5 years when operated at max case temp of up to <75C 3 years from date of manufacture when operated at a max case temp of up to 90C when properly installed and under normal conditions of use. See aceleds.com for complete warranty policy. 3401 Avenue D, Arlington, TX 76011 800-375-6355 www.aceleds.com RoHS Data is based upon tests performed by AC Electronics in a controlled environment and representative performance. Actual performance can vary COMPLIANT depending on operating conditions. Specifications are subject to change without notice. All specifications are nominal unless otherwise noted. LEAD -FREE 2018 Revised 08/08/2018AC-25CD1.25APME Performance Characteristics Phone Instructions First you must have a Android device (phone/tablet) with NFC-V app downloaded. Open App then place the device on top of the driver matching up sensors until it syncs up Basic format Write To Check: Read Insert the appropriate code from chart above Read Write Shows you the Block - 00 00 00 00 Successfully written will appear This is where the code you input appears IOUT/VOUT CURVE Use with NFC-V Reader App Available Free at Google App Store 60 55 50 45 40 35 30 25 20 15 10 5 0 0.2 0.4 0.6 0.8 1 1.2 1.4 Output Current A CONTROL THE IOUT WITH THE PROGRAMMING WAND. DOWNLOAD SOFTWARE FROM