A153PTS-332DDB4040

Position Sensor / Control A15-3P FEATURES Electrical angle: 360 Designed for direct input to microprocessor. SMD, Horizontal or Through-hole Mount Endless Rotation Extended Mechanical Life Working Temperature Range (-40C to +120C) Low Profile (4.4 mm) Linearity (independent): 2% Embossed Tape or Bulk packaging Reflow Soldering capability Plug-in shafts 360 Shaft insertable from both sides Electrical Angle Reflow Polarised rotor (European Home Appliance standard) Fully Soldering Customiseable Ideal for Consumer Control and position sensing applications IP54 protection according to IEC 60529 STANDARD SPECIFICATIONS APPLICATIONS Resistance values*: 3.3k This device is aimed to applications that need on-field arbitrary initial and final travel reference points calibration. Tolerance: 40% Nominal Power: 0.15 W 50C Once these have been set, the A15-3P provides accurate Linearity (independent): 2% position feedback output to the controller. Mechanical Life**: 100K cycles Designed to be a cost-effective replacement for absolute Temperature Range: -40C to +120C encoders, the A15-3P series offers an SMD, Vertical and Mechanical Angle: 360 Through Hole mount solution for the majority of Position/Angle Rotational Torque: 20 mN.m Rotary Sensor and multi-purpose Control applications such as garage door oppeners, gauges, rotary actuators and Max. Voltage: 22 VDC robotics. (*) Others upon request (**) 200K cycles version available upon request SCHEMATIC AND FUNCTIONALITY Vcc Vcc Analog input A S Vcc Taper 1 Taper 2 Taper 3 1 SW 2 75% B E 50% 3 25% MicroP 60 120 120 60 +Vcc 360 HOW TO ORDER A15 3P T S - 332 4040 DDB Mounting Method Series Rotor Value Tolerance Curve code A15 3P T DDB 4040 = 40% V =Through Hole 332 = 3.3 K S = SMD Others upon request NOTES: Shafts are not available mounted to the potentiometer and should be ordered separately Through hole versions will be studied case by case The information contained here should be used for reference purposes only. www.piher.net -1- 360 Electrical Angle NO DEAD BANDSMD MOUNT A S S A E B E B SOLDER DATE VALUE CURVE FOOT - PRINT A Recommended S PCB hole diameter wiper when using listed Piher shafts E B THROUGH HOLE MOUNT S A A S (WITHOUT SOLDER MASK) E E B B SOLDER MASK DATE VALUE CURVE PCB HOLE LAYOUT 2 PCB HOLE LAYOUT 1 A S wiper Recommended PCB hole diameter E B when using listed Piher shafts -2- www.piher.net