100200-4Y100-2

Model 100200-4Y100-2 Surface Mount Resistor 5 Watts, 100 General Specifications Resistive Element Thick film Substrate Beryllium oxide ceramic Thick film silver Terminals Electrical Specifications Resistance Range: 100 ohms, 2% Frequency Range DC 3.0 GHz Features: Power: 5 Watts DC 3.0 GHz Capacitance: 0.8 pF Note: Tolerance is 0.010, unless otherwise specified. Designed to meet of 5 Watts exceed applicable portions of MIL-E-5400. Operating temperature is -55C to 125C (see chart for derating temperatures). BeO Ceramic All dimensions in inches. Specifications subject to change with out notice. Non-Nichrome Resistive Element Low Capacitance 100% Tested Outline Drawing 100200-4Y100-2 (097) Rev C USA/Canada: (315) 432-8909 Available on Tape Toll Free: and Reel For Pick and (800) 544-2414 Place Manufacturing. +44 2392-232392 Europe: Model 100200-4Y100-2 Typical Performance: Power De-rating: Mounting Footprint and Procedure: .025 MIN. (2 PLACES) BOARD LOWER BOARD EVEN BOARD LOWER BOARD HIGHER THAN LEAD. WITH LEAD. THAN LEAD. THAN LEAD. SUGGESTED STRESS RELIEF METHODS NOT RECOMMENDED APPLICATION SCALE: NONE SCALE: NONE SUGGESTED MOUNTING PROCEDURES: MAKE SURE THAT THE DEVICES ARE MOUNTED ON 1. FLAT SURFACES (.001 UNDER THE DEVICE) TO OPTIMIZE THE HEAT TRANSFER. 2. DRILL & TAP THE HEATSINK FOR THE APPROPRIATE THREAD SIZE TO BE USED. 3. COAT HEATSINK WITH A MINIMUM AMOUNT OF HIGH QUALITY SILICONE GREASE (.001 MAX. THICKNESS). 4. POSITION DEVICE ON MOUNTING SURFACE & SECURE USING SOCKET HEAD SCREWS, FLAT & SPLIT WASHER. TORQUE SCREWS TO THE APPROPRIATE VALUE. MAKE SURE THAT THE DEVICE IS FLAT AGAINST THE HEATSINK. (CARE SHOULD BE TAKEN TO AVOID UPWARD PRESSURE OF THE LEADS TOWARDS THE LID). 5. SOLDER LEADS IN PLACE USING APPROPROATE SOLDER WITH A CONTROLLED TEMPERATURE IRON. ** FOR MORE DETAILS CONTACT FACTORY ** 100200-4Y100-2 (097) Rev C USA/Canada: (315) 432-8909 Available on Tape and Reel For Pick and Place Toll Free: (800) 544-2414 Manufacturing. Europe: +44 2392-232392