RoHS Compliant Serial ATA Flash Drive SV250-25 Product Specifications November 8, 2021 Version 1.8 Apacer Technology Inc. 1F, No.32, Zhongcheng Rd., Tucheng Dist., New Taipei City, Taiwan, R.O.C Tel: +886-2-2267-8000 Fax: +886-2-2267-2261 www.apacer.com Specifications Overview: Compliance with SATA Revision 3.2 Temperature Range SATA 6 Gb/s interface Operating: Backward compatible with SATA 1.5/3 Standard: 0C to 70C Gb/s interfaces Wide: -40C to 85C ATA-8 command set Storage: -55C to 100C Capacity Supply Voltage 30, 60, 120, 240, 480, 960 GB 5.0 V 10% Performance* Power Consumption* Burst read/write: 600 MB/sec Active mode: 330 mA Sequential read: Up to 560 MB/sec Idle mode: 95 mA Sequential write: Up to 520 MB/sec Connector Type Random read (4K): Up to 56,000 IOPS 7-pin SATA signal connector Random write (4K): Up to 73,000 IOPS 15-pin SATA power connector Flash Management Form Factor Low-Density Parity-Check (LDPC) Code 2.5 Global Wear Leveling Dimensions: 100.00 x 69.85 x 6.90, unit: mm Flash bad-block management Net Weight: 53g 5% Flash Translation Layer: Page Mapping NAND Flash Type: 3D TLC (BiCS3) S.M.A.R.T. TM DataDefender MTBF: >3,000,000 hours ATA Secure Erase SATA Power Management Modes Device Sleep Security TRIM Trusted Computing Group (TCG) Opal 2.0 Hyper Cache Technology (optional) Over-Provisioning AES 256-bit hardware encryption TM DataRAID ** Reliability TM SMART Read Refresh Thermal Sensor Endurance (in drive writes per day: DWPD) End-to-End Data Protection 30 GB: 3.27 DWPD RoHS Compliant 60 GB: 3.45 DWPD 120 GB: 3.27 DWPD 240 GB: 3.45 DWPD 480 GB: 3.3 DWPD 960 GB: 3.51 DWPD *Varies from capacities. The values for performances and power consumptions presented are typical and may vary depending on flash configurations or platform settings. The term idle refers to the standby state of the device. **Supported on standard model of all capacities and TCG Opal-supported model of 120-960GB capacities. 1 2021 Apacer Technology Inc.