09-Serie 2600-A 09-Serie 2600-A 05/11/14 14:58 Page33 2600 series Power rocker switches Distinctive features and specifications UG1410A Three rocker shapes : plain, V-shaped or concave Various rocker colours Frame with protection guard on 2600LP models Illuminated or non-illuminated UL, CSA, VDE and NF (EN 61058-1) approved ELECTRICAL SPECIFICATIONS Max. current/voltage rating with resistive load and approved ratings : see table below. Initial contact resistance : 10m max. Insulation resistance : 1.000 M min. at 500VDC Dielectric strength : 2.500 Vrms 50 Hz min. between terminals 3.000 Vrms 50 Hz min. between terminals and metal panel Electrical life : 10.000 cycles at full load APPROVED RATINGS DIRECT CURRENT D FUNCTIONS CSA (double pole) UL (double pole) VDE NF 24 VDC 12 VDC CSA 22-2 UL 1054 EN 61058-1 EN 61058-1 1/6 HP 125VAC 1/6 HP 125VAC ON - OFF 16A 125VAC 16A 125VAC 10(4)A 250VAC - 10A 15A ON - ON 16A 250VAC 16A 250VAC T 85/55 1/3 HP 250VAC 1/3 HP 250VAC 10A 125VAC 10A 125VAC L I option L I option ON - OFF - ON 10A 250VAC 10A 250VAC 8A 10A 10(4)A 250VAC 10(4)A 250VAC 1/6 HP 125/250VAC 1/6 HP 125/250VAC ON - ON - ON - - - - 5A 8A 10A 125VAC L I option L I option OTHERS 10A 250VAC - 8A 10A 10(4)A 250VAC 10(4)A 250VAC 1/6 HP 250VAC MATERIALS GENERAL SPECIFICATIONS Case : melamine/polyester Panel thickness : 0,8 mm to 4 mm (.031 to .157) Frame : polyamide Operating temperature : Actuator : polyamide - silver contacts (A) : -20C to +85C Contacts : - silver plated contacts (C) : -10C to +55C A : silver C : copper, silver plated AGENCY APPROVALS EN 61058-1 EN 61058-1 Availability : consult factory for details of approved models. Marking : approved models are standard marked. The company reserves the right to change specifications without notice. APEM www.apem.com D-3309-Serie 2600-A 09-Serie 2600-A 05/11/14 14:58 Page34 2600 series Power rocker switches Overview 26 SERIES Electrical functions Frame type 1 ON - OFF LH Plain 4 ON ON ON LP With protection guard 5 MOM - ON 6 ON - ON 7 MOM OFF MOM 8 ON OFF MOM 9 ON OFF ON double pole only Number of poles Special contact Terminals D 3 Single pole (none) Standard (none) Screw + clamp 4 Double pole /2 Solder lugs /quick-connect /3 Normalized quick-connect ABOUT THIS SERIES On the following pages, you will find successively : - model structure of switches - options in the same order as in above chart Dimensions : first dimensions are in mm while inches are shown as bracketed numbers. Sealing boot U2150 available to protect the switches against dust and water. See section H. NOTICE : please note that not all combinations of above numbers are available. Refer to the following pages for further information. D-34 www.apem.com APEM