CSG22KN6 Apem

CSG series Switch guards for switch series 5000M - 600H DISTINCTIVE FEATURES Modern, patented design Lightweight Anti-tamper wire seal hole as standard GENERAL SPECIFICATIONS APEM SAS patented design Operating temperature : -20 C to +55 C (-4 F to +131 F) Storage temperature : -40 C to +85 C (-40 F to +185 F) Switch guards are designed to prevent accidental lever operation on switches with 11.9 (.468) or 12 (.472) threaded bushing and lever length 17.5 (.688) outside bushing. When the guard is raised, the lever can be operated freely. When the guard is fully depressed, the lever is locked in a stable position. Please note that these guards are not intended to reset the actuator in the desired position. For correct switch operation, the switch guard should be adjusted properly (see Mounting below). MATERIALS Support plate : thermoplastic Cap : thermoplastic MOUNTING PANEL CUT-OUT FOR BUSHING WITH KEYWAY K Standard With K sealing option The company reserves the right to change specifications without notice. 1 CMSGCTK CMSGCTF Fichier: CMSGCT Echelle: 1 le 04-02-2014 SW-CSG-1802 PANEL SWITCHESCSG series Switch guards for switch series 5000M - 600H BUILD YOUR PART NUMBER CSG SERIES NUMBER OF POSITIONS CUT-OUT TYPE COLORS For bushing 2 positions Blue 2 1 K with keyway Black 2 Green 3 SWITCH GUARD TYPE CUT-OUT ORIENTATION Grey 4 Locked in down position North 2 N Yellow 5 Locked in either position South 5 S Red 6 White 7 Orange 9 ABOUT THIS SERIES On the following pages, you will find successively basic part numbers and options in the same order as in above chart. Notice : please note that not all combinations of above numbers are available. Refer to the following pages for further information. Mounting accessories : supplied with the switch or to order separately (see Hardware section of website). 2 PANEL SWITCHES