QS series Snap-in panel mount LED indicators DISTINCTIVE FEATURES 6 mm, 8 mm, 10 mm and 12 mm cut-out sizes Front panel snap-in mounting requires no additional hardware Standard intensity diffused LED or high brightness LED for daylight viewing GENERAL SPECIFICATIONS Operating Temperature Range: -30 C to +65 C ( 22 F to +149 F) Max Reverse Voltage: 5 V Life Expectancy: 100,000 hours Max Panel Thickness: 11 mm MATERIALS Moulded polycarbonate MOUNTING QS6 SERIES PANEL CUT-OUT QS10 SERIES PANEL CUT-OUT QS8 SERIES PANEL CUT-OUT QS12 SERIES PANEL CUT-OUT The company reserves the right to change specifications without notice. LED characteristics are dependent upon environmental conditions. Therefore published data should be considered nominal and subject to variations. 1 IND-QS-17-07 LED INDICATORSQS series Snap-in panel mount LED indicators ELECTRICAL SPECIFICATIONS Voltage Operating Voltage Operating Current STANDARD LED INTENSITY (Min to Max) (Typical All Types) LED COMPONENT SPECIFICATIONS 05 (No Resistor) 2.1 to 3.3 VDC 20 mA max 6 mm 8, 10 & 12 mm Forward Voltage Intensity Intensity 6 VDC 5.4 to 6.6 VDC 20 mA HE Red 40 mcd 100 mcd 2.0 V 12 VDC 10.8 to 13.2 VDC 20 mA Green 40 mcd 60 mcd 2.2 V 24 VDC 21.6 to 26.4 VDC 20 mA Yellow 30 mcd 50 mcd 2.1 V 28 VDC 25.2 to 30.8 VDC 20 mA Blue 1,200 mcd 1,600 mcd 3.8 V 110 VAC White (clear) 1,200 mcd 1,600 mcd 3.8 V (not available 99 to 110 VAC 6 mA Bi-color (Typical) on QS6) 60 mcd 45 mcd 2.0 V (Red/Green) 220 VAC Tri-color (Typical) - 60/15/13mcd 2.5 V (not available 207 to 253 VAC 3 mA (Red/Green/Yellow) on QS6) Bi-color - The color is changed by reversing the polarity of the supply voltage. Tri-color - The indicator has red and green LEDs, when both connected yellow is produced. * Customer to supply resistor for desired operating current. HIGH BRIGHTNESS LED INTENSITY LED COMPONENT SPECIFICATIONS 6 mm 8, 10 & 12 mm Forward Voltage Intensity Intensity HE Red 3,700 mcd 6,000 mcd 2.2 V Green 2,000 mcd 1,900 mcd 3.2 V Yellow 1,200 mcd 2,100 mcd 2.0 V Orange 4,500 mcd 4,500 mcd 2.2 V The operating voltage must not be exceeded by more that 10% as this will result in reduced life expectancy Luminous intensity is measured at 20 mA on a discrete led unless otherwise stated. Luminous intensities and color shades of white LEDs may vary within a batch. Luminous intensity will be reduced with lower operating current. 2 LED INDICATORS