0.060 STATFREE T2 DISSIPATIVE RUBBER Color Dissipative Layer Specifications Standard Document Meets Requirements of: ANSI/ESD S20.20 Worksurface Electrical Properties Typical Values Test Procedures/Method Dissipative Surface Layer 6 9 Rtt Resistance: 1 x 10 to < 1 x 10 ohms ANSI/ESD S4.1 and ESD TR53 6 9 Rtg Resistance: 1 x 10 to < 1 x 10 ohms ANSI/ESD S4.1 and ESD TR53 Ground Plane Layer 6 Rtt Resistance: < 1 x 10 ohms ANSI/ESD S4.1 and ESD TR53 Physical Properties Conductive Black Layer Construction: Dual-layer rubber material Thickness: 0.060 (1.5mm) Color: Blue (Top), Dark Blue (Top), Dark Grey (Top), Green (Top), Black (Bottom) 2-Layer Embossing: Slight Texture Weight: 0.43 lbs./sq. ft. (0.2g/cm2) Grounding & Cleaning Hardness: 65 5 Shore A, per ASTM-D2240 If the material is used on top of an already properly grounded surface, grounding hardware may not be necessary. Where no properly Other Properties Heat Resistance: Does not melt or burn when coming into contact with hot solder and soldering irons. grounded surface is available, grounding hardware is required to provide Chemical Resistance: Resistance to degradation by inorganic acids, organic acids, reducing agents, aliphatic a path-to-ground. Rtg compliance verification measurements must be hydrocarbons, mineral oil, aldehydes, and amines. made as outlined in ESD TR53 with a surface resistance meter. Rubber material isvulcanized and may contain sulfur. See Tech Bulletin TB-7000 for Reztore Surface & Mat Cleaner Color and texture may vary between lots and mills. Application Instructions. Limited Lifetime Warranty: Tolerances: Desco warrants for one year that Statfree matting products will be free Width 0.250 of defects in materials and workman ship and will guarantee dissipative/ Length 0.250 every 1 linear foot of running material. conductive mat properties for the life of the mat. Damage to matting Thickness 10% caused by misuse of any kind, including using inappropriate cleaners is not covered by Desco Limited Warranty. Matting materials have a tendency to shrink slightly when first unrolled. In applications where length is critical, allow the material to condition for at least 4 hours before cutting to size. Always using care trim with a sharp knife or razor blade. RoHS 3, REACH, and Conflict Minerals Statement See the Desco Industries RoHS 3, REACH, and Conflict Minerals For product listings, Click Here Statement: X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for Antistatic Control Products category: Click to view products by Desco manufacturer: Other Similar products are found below : 13020 13490 13870 13879 13881 13883 13882 14404 2202SP 3039 37061 42470 09060 09857 42516 37059 04563 17252 19691 19695 09037 09826 09813 66070 100816 68101 68103 98132 73741 13868 13485 13457 13245 13468 13420 13332 13205 13135 91070 8031 8523 66085 40931 37081 13080 13215 13806 73749 010-0225 17260