3M Workstation Products Selection Guide Image Product No. Description Common Point Grounding System, 10 ft. (3 m) to ground workstation components. Single-row, six-terminal strip, protective cover, three cable clips. Ground cord has a 3047 1 megohm resistor. Grounding System for 3M Wrist Strap/Table Mat. Easily snaps onto mats and runners, (10 mm snap) grounds two single conductor wrist straps. Comes complete with ring 3048 connector and 15 ft. (4.6 m) ground cord. Ground cord has a 1 megohm resistor for mat connection only. This low profile common point ground cord is less obtrusive in the work area. The system connects two wrist straps and a work surface to ground. Holes are provided for LPCGC151M permanent mounting to a bench. Available with either a 3/8 in. (10 mm) stud or socket that securely snaps the cord to the mat. A ring terminal connects the opposite end of LPCGC150M the 15 ft. (4.6 m) cord to ground. Snap Fastener, female, 10 mm diameter. For 3M Table and Floor Mats and Runners 3050 8200 Series. Ground Cord with center snap for standard field service kits. Wrist strap cord section 3051 10 ft. (3.0 m) and ground cord section 5 ft. (1.5 m). Each contains a 1 megohm resistor. Monitor Stand-By Jack. Allows operator to disconnect a ground cord from the wrist band and leave the workstation without deactivating the 3M Wrist Strap Workstation 3057 Monitor 724 or 3M Static Monitor 790. Soldering Tool. 3Ms SP3010 Soldering Tool will help you form component leads, probe circuit cards, and chase wire and leads. Tough glass-filled nylon plastic makes this tool SP3010 durable and long lasting. This simple-to-use tool attaches snaps to static mats. Three easy steps give you a secure snap with good electrical connection. Rugged and rust resistant, the snap tool SNAPTOOL allows you to put a grounding snap right where you need it. Socket snaps are held in place by crimping the tip of an eyelet through the center of the socket with a snap tool. This traps the mat between the socket on the top of the SNAPSOCKET3/8 mat and the eyelet on the back of the mat. 10 sockets and eyelets are included in each pack. Use with SNAPTOOL. Stud snaps are held in place by crimping the tip of an eyelet through the center of the stud with a snap tool. This traps the mat between the stud on the top of the mat and the eyelet on SNAPSTUD3/8 the back of the mat. 10 studs and eyelets are included in each pack. Use with SNAPTOOL. Prong clinch snaps are held in place by putting the prongs through the mat and crimping FPSNAP them on the bottom of the mat. No special tools are needed.X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for AntiStatic Control Products category: Click to view products by SCS manufacturer: Other Similar products are found below : 13505 13870 14404 20-053-0017 2229 2231 3039 37061 39792 42470 XON-ASB4X30 XON-ASB4X6 XON-ASB6X30 09813 09857 XON-ASB8X10 XON-ASB6X10 19695 09037 68101 68103 73741 13515 13869 13868 13485 13457 13245 13332 13205 13135 91070 8031 8523 13080 13215 157 ROLL BEIGE 1.0 VERAX1R-300R 17260 66051 12550 19863 09121 73831 13340 13338 04541 19696 16104 SPI-20686