3.2mm Round Optopipe Optical Light Pipe, 2 Array, Panel Mounted 515-1033 LEDs for use with 19.05 .75 REF 515-1033 2.79 .110 REF Recommended PAGE .61 .024 .99 DIFFUSED DIRECTION .039 TYP FRONT SURFACES OF LIGHT 521-9247 6-44 TOP SURFACE OF LED 521-9249 6-44 .51 4.57 FRONT 521-9251 6-44 13.97 .020 .18 TYP 5.08 PANEL .550 MAX (2) PLACES .200 550-xx10 6-17 (2) PLACES 550-5504 6-9 550-5505 6-11 550-5507 6-13 550-5508 6-15 1.78 PRESS-FIT 550-5604 6-9 .07 RIBS TYP, 3 PLCS MAJOR DIA. 550-5605 6-11 4.32 3.20 3.71 0.146 .17 .126 550-5607 6-13 2 PLACES 550-5608 6-15 550-5704 6-9 Dimensions in mm inches 550-5705 6-11 550-5707 6-13 550-5708 6-15 Features High transmissivity polycarbonate material UL94V-0 compliance Alternatives ESD protection (circuit isolation from front panel) 521-9430 4-61 Wide viewing angle 521-9431 4-61 521-9432 4-61 Arrays reduce insertion costs Secures to panel by press-fit LED alternatives may not produce optimum light (Also recommend supplement means of securing -- output for example, clamping) Operating/Storage Temperature LED Data For absolute maximum ratings and other electrical and optical 30C to +100C data on the recommended LEDs, refer to LED data sheets. Dialight Optopipe Light Pipe Description This Optopipe is clamped to the inside of the plastic panel. The light pipe is not attached to the PCB at any point but floats in front of it. The splines on the tubular section on the right hand side hold the light pipe in place for the clamping operation. The funnel end faces the light source. The tubular sections fit through the plastic panel. The light emitting sur- face is textured to diffuse the light passing through it. The light source can be any super-bright 2mm, 3mm, or 5mm LED, or one of Dialights 597 Series SMT LEDs. The light sources emitting surface should be located no more than 0.020 or 0.5mm from the Optopipe . The light sources are mounted in a straight line facing the rear of the light pipe on a 14mm pitch. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe solutions for your applications. Dialight Corporation 1501 Route 34 South Farmingdale, NJ 07727 TEL: (732) 919-3119 FAX: (732) 751-5778 www.dialight.comX-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for LED Light Pipes category: Click to view products by Dialight manufacturer: Other Similar products are found below : 1367627-1 SLP3-300-450-F SLP3-400-450-R LPA-C011301S-23 LPA-C011301S-6 LPF-C011306S FLP25-1.95 VLP-640-F LPA- C011301S-5.4 LPA-C041301S-2 LPA-R051171S-12 LPA-S011331S 515-1027-803F 515-1217F SLP3-150-300-R SLP3-500-450-R 515- 1064-810F FLPV-SG BDL-1187 7511A41 7511A87-500 FLPV-SBC 5151064802F 5151-192-0055-0DF LPF-R011340S 515-1166-801F FLPF-6.0 SLP3-350-200-F PM4-C1522-3.70 LC-11.25 CLP-1214 515-1064-808F FLX3 05 515-1192-0025-0DF 515-1192-80-3DF PBLP- 1001-1 LC2-4.1 LPC062CTP LSS024CTP LPC088CTP SLP3-150-300-F 2202312 515-1302-0500F RLP1-200-800 RLP1-400-500 LPA- C011301S-15 2202311 SLP3-150-450-R 7511A53 1270.1003