DI DANIELS MANUFACTURING DBS-1200 CORPORA T/ON ..., MANUAL BANDING TOOL DATASHEET SEE PAGE 2 FOR IMPORTANT INFORMATION CONCERNING LIMITED WARRANTY, AND LIMrTATION OF LIABILITY. APPLICATION EMI/RFI bands meeting AS85049 /128 Rev. A and other OEM standards. The Daniels DBS-1200 Series Manual Banding Tools comply with all performance requirements set forth in AS85049 /128 Rev. A. INTRODUCTION The Daniels DBS-1200 (M81306/2-01 B) Manual Banding Tool 1s primarily designed for termination of EMI/RFI shielding materials. BAND (LOOP FACING UPWARD AS SHOWN) 1.0 OPERATION NO S E -- -- =:::::::::: -----: :::r- 1.1 Insert the mechanical band into o the DBS-1200 Banding Tool at Q least 1. 75 inches, the band loop shall be oriented on the upper side of the tool s nose (see Figure 1 ). Actuate the movable handle of the tool one complete stroke to insure that the band has been captured by the gripping mechanism. MOVABLE The band must be double-looped as HANDLE shown in Figure 6. FIGURE 1 1.2 Position the connector and the shield assembly through the band allowing the connector to be on the left side of the tool. 1.3 Orientate the shield terminations under the band while actuating the movable handle of the tool. Continue tool actuation until the band is snug and tool resistance is felt, then release the movable handle and actuate the handle one full stroke thus locking the movable handle (locking occurs at the predetermined poundage). DO NOT ATTEMPT TO PULL THE HANDLE OF THE TOOL OPEN. WHEN THE BAND IS CUT, THE MOVABLE HANDLE WILL OPEN AUTOMATICALLY. DANIELS MANUFACTURING CORP., 526 THORPE ROAD, ORLANDO, FL 32824, USA, PHONE 407/855-6161, FAX 407/855-6884 COPYRIGHT (C) 2015 DANIELS MANUFACTURING CORP., USA. WWW.DMCTOOLS.COM E-MAIL: DMCOOMCTOOLS.COM ALL RIGHTS RESERVED 5/15 REV. J DBS-1200-DS PAGE 1 ..... DANIE.LS ,,,. MANUFACTURING -.., CORPORATION DATASHEET 1. 4 At any point in the operation prior to the locking of the movable handle, the band may be loosened or removed by disengaging the retention pawl as shown in Figure 2. When actuating the retention pawl, apply a force on the band away from the tool to remove or loosen the band. RETENTION PAWL MOVABLE HANDLE FIGURE 2 LIMITATION OF LIABILITY DANIELS MANUFACTURING CORPORATION IS NOT LIABLE FOR CONSEQUENTIAL OR SPECIAL DAMAGES OF ANY NATURE OR KIND RESULTING FROM THE USE, OR MISUSE, OF ANY OF ITS PRODUCTS. OWNERS AND USERS OF DMC PRODUCTS ASSUME FULL RESPONSIBILITY FOR INSTRUCTING THEIR EMPLOYEES IN THE PROPER AND SAFE USE OF SUCH PRODUCTS. LIMITED WARRANTY DMC (Daniels Manufacturing Corporation) warrants each new product sold by it to be free from defects in material and workmanship under normal DMC s obligation under this warranty is limited to the free use and service. correction or, at DMC s option, the refund of the purchase price of any such product which proves defective in normal service within ninety (90) days after delivery to the first user, provided that the product is returned to DMC with all transportation charges prepaid and which shall appear to DMC s satisfaction, after DMC s inspection, to have been defective in material or workmanship, it being understood that DMC products are not consumer products. This warranty shall not cover any damage to any product which, in the opinion of DMC, was caused by normal wear, misuse, improper operation, tampering, neglect or accident. This warranty is in lieu of all other warranties express or implied. No warranty, express or implied, is made or authorized to be made or assumed with respect to products of Daniels Manufacturing Corporation other than those herein set forth. PAGE 2