MSX. Connecting clamps FM Design technical informations Base Glass-fibre reinforced polyamide based (PA) technopolymer, black colour, matte finish. Fitting by means of a stainless steel M5 cylindrical-head screw with hexagon socket and nut. T-shaped clamp Glass-fibre reinforced technopolymer, black colour, matte finish. Fitting by means of stainless steel M5 cylindrical-head screws with hexagon socket and nuts. Device clamps Glass-fibre reinforced technopolymer, black colour, matte finish. Fitting by means of a stainless steel M5 cylindrical-head screws with hexagon socket and nuts. Features and applications The geometry of the holes of MSX. series connecting clamps are designed to fit both tubes with round cross section and tubes with square cross section the latter prevents the elements from rotating (see Fig. 1). Assembly instructions 1 - Fit the base by means of 2 M6 cylindrical-head screws with hexagon socket (not supplied). 2 - Fit the connecting tube into the hole of the base and clamp it by screwing the set screw. Suggested tightening torque 5 Nm. 3 - Insert the T-shaped clamp which allows the assembly of another connecting tube. 4 - Fit the other connecting tube into the hole of the T-shaped clamp. 5 - Fit onto the connecting tube the desired device clamp chosen among the six available ones. After the positioning of the components, clamp them by screwing the set screws. Suggested tightening torque 5 Nm.