SFP+a Breather caps with splash guard and flat dipstick ELESA Original design technical informations Cover and threaded connector Polyamide based (PA) technopolymer. Resistant to solvents, oils, greases and other chemical agents. Colour - Cover: RAL 2004 orange, semi-matte finish, markedOI. - Threaded connector: black, semi-matte finish. Flat packing ring NBR synthetic rubber. Flat dipstick Phosphatised steel. On request and for sufficient quantities dipstick can be supplied in different lengths and/or complete with MAX-MIN level lines. Splash guardTechnopolymer. Standard executions available - SFP+a: without air filter (black splash guard). - SFP+F+a: D = 31, 42 and 57 withtech-fi air filter in zinc-plated steel wire (orange splash guard) D = 70 withtech-foa air filter in polyurethane foam mesh (polyester base), air filtration 40 (grey splash guard). - SFP.70-BA+F+a: withtech-foa air filter in polyurethane foam mesh (polyester base), air filtration 40 (grey splash guard) and zinc-plated steel sheet bayonet and chrome-plated steel safety chain. Maximum continuous working temperature 120C for execution without air filter or withtech-fi air filter. 100C for execution withtech-foa air filter. Special executions on request (For sufficient quantities) - Cover, RAL 2004 orange, withoutOI mark. - Black cover with or withoutOI mark. Features and applications SFP+a breather caps come complete with splash guard device (ELESA originale design) that prevents oil loss and are particularly suitable for use where oil is violently agitated and could be splashed against the breather cap. Technical data Air flow rate for each model can be determined from the graph calculating the difference between the pressure inside and outside the reservoir.