UG-23D/U(40)

N type Coaxial Connectors N Series Features 1. 50 ohms wide varieties standard connectors 2. Screw on locking 3. Applicable cable : RG cable, JIS cable 4. Applicable standard : MIL-C-39012/MIL STD 348-304 Functional diagram Plugs Jacks Straight plug for flexible cable Straight jack for flexible cable In-line adapters UG-21D/U(40) UG-23D/U(40) Right angled jack-plug type UG-27C/U(40) Straight plug for semi-rigid cable Panel mount jack for flexible cable T-type adapter N-P-141(40) N-PJ-58/U(40) Jack-plug-jack type UG-107B/U(40) Right angled plug for flexible cable Panel mount straight receptacle Fixed attenuator N-LP-5DW(40),N-LP-58U(40) UG-58A/U(40) Plug-jack type AT-4** Conversion adapters Conversion adapters BNC series conversion type BNC series conversion type In-line adapters S series conversion type TNC series conversion type SMA(HRM series) conversion type Straight plug-plug type SMA(HRM series) conversion type UG-57B/U(40) Cap with a chain MX-913/U(40) In-line adapters Straight jack-jack type UG-29B/U(40) Non-reflective Terminators Panel mount adapter N-TMP-* Jack-jack type N-PA(40) T-type adapter Jack-jack type UG-28A/U(40) In cases where the application will demand a high level of reliability, such as automotive, 2018.7 1 please contact a company representative for further information.N SeriesN type Coaxial Connectors Product Specifications Nominal characteristic impedance 50 Operating temperature range -30C to +60C Ratings Frequency range DC to 2GHz Operating humidity 95%RH max. Item Specification Conditions 1. Contact resistance 3m max. 100mA max. 2. Insulation resistance 1000M min. 500V DC 3. Withstanding voltage No flashover or insulation breakdown. 1500V AC / 1 minute 4. V.S.W.R.* 1.2 max. Up to 2GHz 5. Durability (mating / un-mating, 10m max. 500 cycles with corresponding plug) 6. Vibration Frequency : 10 to 500Hz, single amplitude of 0.75mm, acceleration 2 of 98m/s , for 10 cycles in the direction of each of the 3 axis. No electrical discontinuity of 1s min. 2 No damage, cracks or parts dislocation. 7. Shock Acceleration of 490m/s , 11ms duration, sine half-wave waveform, 3 cycles in each of 3 axes. 8. Humidity No damage, cracks or parts dislocation. 96 hours at temperature of 40 and humidity of 80% to 96%. (Steady state) Temperature : -55C/+25 to +65C/+85C/+5 to +35C 9. Temperature cycle No damage, cracks or parts dislocation. Time : 30min./ 5min. /30min. / 5min. 5 cycles 10. Salt spray No excessive corrosion 5% salt water solution, 48 hours *V.S.W.R. Measurement System The above V.S.W.R. standard values were measured using the measurement connection as shown below. Network Analyzer Test Set Test Port D.U.T Termination Test Port Cable Note 1 : Connectors with cable are measured with 10cm of suitable cable attached at both ends. Material / Finish Part Material Finish Remark Shell Brass Silver plated/Nickel plated Male contact Brass Silver plated/Gold plated Female contact Beryllium copper Silver plated/Gold plated Insulator Tetrafluoride resin Flame retardant Packing Silicone rubber Flame retardant Product Number Structure Refer to the chart below when determining the product specifications from the product number. Please select from the product numbers listed in this catalog when placing orders. Standard Product with MIL standard - - N L P 5DW UG- 21 D /U 1 2 3 4 1 2 3 1 1 Series name : N 3 Connector type High freguency coaxial connectors 1 : 2 Connector style P Plug 2 Product identification number Blank : Straight type J : Jack Improved sign 3 : : L L angle type PJ Panel jack : : T T angle type R Receptacle A : Adapter : PA Panel adapter 4 Applicable cable 2