iglidur J Low friction, low wear: The Fast and Slow Motion Specialist iglidur J Over 250 sizes available from stock Low wear against different shaft materials Low coefcients of friction running dry Vibration dampening Good chemical resistance Best material to use with soft shaft materials Low moisture absorption 109 iglidur J iglidur J The Fast and Slow Motion Specialist Low friction, low wear. The iglidur J plain bearings are designed for the lowest coefcients of friction while running dry and low stick slip tendency. With a maximum permissible surface pressure of 35 MPa iglidur J plain bearings are not suitable for extreme loads. Low wear against When to use it different shaft materials For high speeds For highest wear resistance at low to medium pressures Low coefcients Low wear against different shafts of friction running dry Low coeffcient of friction in dry run Vibration dampening Good chemical resistance Best perfomance with soft shaft materials Low moisture absorption Vibration dampening When not to use it Good chemical resistance When high pressures occur iglidur G, page 81 iglidur W300, page 151 When short term temperatures occur that are greater +120 C iglidur J350, page 257 Best material to use iglidur Z, page 327 with soft shaft materials When a low-cost bearing for occasional movements is necessary iglidur G, page 81 Low moisture absorption Temperature Product range 3 types +90 > 250 dimensions 1.5139 mm 50 110 More information www.igus.eu/eu/j