4937

Solderless LED Flex Connector from Inspired LED Easy enough to terminate strips in the field - Reliable enough to terminate strips ahead of time. 1. Cut Flex Strip to length at line (after each set of three LEDs.) * 2. Locate (+) marking on Flex Strip and align with (+) marking on Connector. + 3. Peel adhesive backing of LED Connector Base Flex Strip back approximately 2. Open Lock Connector Latch 4. Holding latch open with thumb and forefinger slide Flex Strip fully into connector, slide latch to full lock position and press Flex Strip onto Connector Base. 5. Test strip to ensure that you have full insertion and that polarity is correct. 6. Install when ready by removing adhesive backing from Connector Base. *Some cut points are presoldered, these points cannot be terminated with this connector. In this instance cut strip one section short. The spread of the light will make 3 fewer LEDs unnoticeable. Technical Features > Provides Solderless termination to from LED Flex Strips to popular LED connectors. > Termination for both 8 and 10mm wide LED Flex Strips. > Direct connection to most Class 2 Power Supplies. > Easy board to board connection through off the shelf Cable Assemblies. > Allows for assembly and testing on the bench before installation. > Industry proven locking system meets shock and vibration requirements of IEC 60068-2-27 > Use only in indoor applications. 48mm 20mm 4937 17mm 5.5 x 2.1 mm DC Connector - 4938 3.5 x 1.3 mm DC Connector - 4939 Wire termination includes detachable 2 pin - Screw Terminals 24-12 AWG Inspired LED 1733 E McKellips Rd. 112 Tempe, AZ 85281 (480) 941-4286 www.inspiredled.com Tiger Paws, How to. Detailed Description. 1) 3) 2) Tiger Paws come in pairs, to If they are still connected together, ensure that both ends of a flexible break them apart along the scored Notice the different LED strip can be terminated. center line. polarities, marked by the + and symbols. Closed Opened 4) 5) 6) Now select the tiger paw that matches the polarity of the flexible LED strip end you would like to terminate. Peel back the Also notice the LED connector it adhesive liner on the LED strip about 1.5 Insert the flexible LED strip into the open opens for easy strip insertion and inches. Please note that solder pads with a LED connector: above the sliding latch and latches to secure the connection. bump of solder on them cannot be below the beige top. Again, make sure that terminated with this item. the positive side of the strip matches the positive side of the board. 7) 8) 9) Reinforce the connection by Secure the LED connector by pressing and sticking the flexible Make sure the LED strip is centered and closing the sliding latch. Again, the strip to the rest of the connector fully inserted into the LED connector. adhesive may want to resist. Your board. You may need to hold the latch open with thumb nails are your friend here. one hand so that the adhesive doesnt pull the latch closed prematurely. Plug it in, to verify the connection. 10) If there is any flickering, make sure flex is fully inserted and that the latch is secure. If no lights turn on, check polarity. Inspired LED 1733 E McKellips Road Suite 112 Tempe, AZ 85281 (480) 941-4286