110238-0481 ITT

Contacts ZIF Connectors Contacts Contacts he Cannon DL Crimp and Buss contacts are available in addition to the factory T installed Square Post/PCB mount version contacts. Crimp contacts are available loose or reeled, where as Buss contacts are available loose only. The Buss contacts make the DL series capable of providing higher than 5 amps per line. The Buss contacts are pairs of contact lines which increase the amperage capability in increments of 10 amps up to 60 amps. The contacts have solder holes at the tail section for soldering 30- 18 AWG. The tail is also designed to accommodate a 1/8N crimp lug for wire sizes larger than 18. The Crimp contacts are available in two plating types. The 20m inch gold hermaphroditic version which is the economical choice for applications requiring over 100 milliamps to 5 amps. And the 50m inch gold BUMP to FLAT version which offers t h e m o s t v e r s a t i l e r a n g e o f a p p l i c a t i o n requirements from micro-amps to 5 amps. The BUMP to FLAT version was developed specifically to handle dry circuit requirements where the signal amperage is not enough to ensure a clean contact point. The 50m inch gold BUMP to FLAT version is mandatory for applications with signals below 100 milliamps. The Bump contact is installed in the Plug and the ensures that the wiping point becomes the current for all modern applications where power and low Flat contact is installed in the Receptacle. This carrying point after mating. The 50m inch gold voltage signals are combined into one connector. combination increases the contact force and BUMP to FLAT version has become the standard Materials and Finishes Description Material Finish Crimp Contact* Copper Alloy Gold over nickel or Selective gold/tin lead over nickel Buss Contact Copper Alloy Gold over nickel *Order crimp contacts separately. See pages 52-53. Dimensions are shown in mm (inch) Dimensions subject to change 50 PDFINFOPDFINFO ZZ II FF -- 00000 0 5 0 50-K 50-CZIF Connectors Contacts Buss Contacts 6 Pair/3Pair/1 Pair 1 Pair 1 Designed for power distribution of more than 5 amps. 1 Accommodates 30- 18 AWG in hole X 1,29-1,14 (.051-.045) for wire soldering. Buss Contact 1 Accommodates 1/8N crimp lugs for larger wire Description Part Number sizes. 1 Pair 030-7380-001 2 Pair 030-7380-002 3 Pair 030-7380-003 Material: Copper Alloy 4 Pair 030-7380-004 5 Pair 030-7380-005 Finish: 20m inch in mating area/ gold flash on balance (terminating end) 6 Pair 030-7380-006 Note: For more information on tools and assembly, see pages 54-59. Wire Termination Solder Wire Termination Crimp Lug Dimensions are shown in mm (inch) Dimensions subject to change 51 PDFINFO Z I F - 0 0 5 1 51-K 51-C Contacts