U1176A Keysight

Agilent U1176A LED Probe Clip Light Operating Instructions This LED probe clip light is designed for used with Agilent handheld digital multimeters. The LED probe clip light helps make measurements easier while using handheld digital multimeters in dark places. Assistance For technical assistance, contact your nearest Agilent Sales Office or visit the Agilent website at www.agilent.com/find/assist for further information. Product Characteristics OPERATING ENVIRONMENT: Operating temperature from 10 C to 55 C. STORAGE ENVIRONMENT: Storage temperature from 20 C to 60 C. RELATIVE HUMIDITY (R.H.): Relative humidity up to 80% for temperature up to 30 C, decreasing linearly to 50% R.H. at 55 C. POWER CONSUMPTION: 90 mVA for single 1.5 V AAA battery BATTERY TYPE: Alkaline 24 A (ANSI/NEDA) and LR03 (IEC), or Zinc Chloride 24 D (ANSI/NEDA) and R03 (IEC). DIMENSION (W L H): 16.3 mm 80.0 mm 33.5 mm WEIGHT: 25 g with battery ELECTROMAGNETIC COMPATIBILITY (EMC): Susceptibility and emissions: Commercial limits per EN61326-1, Pollution Degree II Environment and altitude up to 2000 m. When using the LED probe clip light for the first time, remove the insulating material situated between the anode of the battery and the circuit. Do not open the plastic case unnecessarily. Doing so may cause damage to the plastic case. Keep the LED probe clip light away from getting wet. Ensure the LED probe clip light is turned OFF and the battery cover removed when replacing the battery. Remove the battery when not using the LED probe clip light for a long time. If the LED probe clip light is not lighted when turned on, replace with a specified battery. The battery must be recycled or disposed properly after depletion. The LED probe clip light can only be used with handheld digital multimeters or test leads from Agilent.Operation Using the probe clip light 1. Remove the battery insulator from the body of the LED probe clip light before first use. 2. Push and lock the button to turn the probe clip light ON. 3. Push and release the button to turn the probe clip light OFF. Replacing the battery 1. Ensure the LED probe clip light is turned OFF. 2. Slide the battery cover away from the body of the LED probe clip light.