AAA3528QWDSURKS Kingbright

3.5x2.8mm SURFACE MOUNT LED LAMP Part Number: AAA3528QWDSURKS ATTENTION White OBSERVE PRECAUTIONS Hyper Red FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Descriptions z Both chips can be controlled separately. z The source color devices are made with InGaN Light z Suitable for all SMT assembly and solder process. Emitting Diode. z Available on tape and reel. z The Hyper Red source color devices are made with z Package: 2000pcs / reel. AlGaInP on GaAs substrate Light Emitting Diode. z Moisture sensitivity level : level 3. z Electrostatic discharge and power surge could damage z RoHS compliant. the LEDs. z It is recommended to use a wrist band or anti- electrostatic glove when handling the LEDs. z All devices, equipments and machineries must be electrically grounded. Package Dimensions RED WHITE Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01") unless otherwise noted. 3. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. 4. The device has a single mounting surface. The device must be mounted according to the specifications. SPEC NO: DSAL0998 REV NO: V.4A DATE: SEP/01/2014 PAGE: 1 OF 8 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Y.Liu ERP: 1201006998 Handling Precautions Compare to epoxy encapsulant that is hard and brittle, silicone is softer and flexible. Although its characteristic significantly reduces thermal stress, it is more susceptible to damage by external mechanical force. As a result, special handling precautions need to be observed during assembly using silicone encapsulated LED products. Failure to comply might lead to damage and premature failure of the LED. 1. Handle the component along the side surfaces by using forceps or appropriate tools. 2. Do not directly touch or handle the silicone lens surface. It may damage the internal circuitry. 3. Do not stack together assembled PCBs containing exposed LEDs. Impact may scratch the silicone lens or damage the internal circuitry. 4.1. The inner diameter of the SMD pickup nozzle should not exceed the size of the LED to prevent air leaks. 4.2. A pliable material is suggested for the nozzle tip to avoid scratching or damaging the LED surface during pickup. 4.3. The dimensions of the component must be accurately programmed in the pick-and-place machine to insure precise pickup and avoid damage during production. 5. As silicone encapsulation is permeable to gases, some corrosive substances such as H S might corrode silver plating of 2 leadframe. Special care should be taken if an LED with silicone encapsulation is to be used near such substances. SPEC NO: DSAL0998 REV NO: V.4A DATE: SEP/01/2014 PAGE: 2 OF 8 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Y.Liu ERP: 1201006998