WP710A10ID14V Kingbright

T-1 (3mm) SOLID STATE LAMP Part Number: WP710A10ID14V ATTENTION High Efficiency Red OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Descriptions z Low power consumption. z The High Efficiency Red source color devices are made z Popular T-1 diameter package. with Gallium Arsenide Phosphide on Gallium Phosphide z General purpose leads. Orange Light Emitting Diode. z Reliable and rugged. z Electrostatic discharge and power surge could damage z Long life - solid state reliability. the LEDs. z Available on tape and reel. z It is recommended to use a wrist band or anti- z 14V internal resistor. electrostatic glove when handling the LEDs. z RoHS compliant. z All devices, equipments and machineries must be electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAL0506 REV NO: V.5A DATE: JAN/22/2015 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101029207 Selection Guide Iv (mcd) 2 Viewing V= 14V Angle 1 Part No. Dice Lens Type Min. Typ. 21/2 10 20 WP710A10ID14V High Efficiency Red (GaAsP/GaP) Red Diffused 40 *5 *10 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. Units Test Conditions peak Peak Wavelength High Efficiency Red 627 nm VF=14V D 1 Dominant Wavelength High Efficiency Red 617 nm VF=14V 1/2 Spectral Line Half-width High Efficiency Red 45 nm VF=14V IF Forward Current High Efficiency Red 10.5 13.5 mA VF=14V IR Reverse Current High Efficiency Red 10 uA VR = 5V Note: 1.Wavelength: +/-1nm. 2.Wavelength value is traceable to the CIE127-2007 compliant national standards. 3.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter High Efficiency Red Units Power dissipation 160 mW Forward Voltage 16 V Reverse Voltage 5 V Operating Temperature -40C To +70C Storage Temperature -40C To +85C Lead Solder Temperature 1 260C For 3 Seconds Lead Solder Temperature 2 260C For 5 Seconds Notes: 1. 2mm below package base. 2. 5mm below package base. SPEC NO: DSAL0506 REV NO: V.5A DATE: JAN/22/2015 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: L.Q.Xie ERP: 1101029207