WP710A10SGD14V Kingbright

T-1 (3mm) SOLID STATE LAMP Part Number: WP710A10SGD14V ATTENTION Super Bright Green OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Descriptions z Low power consumption. z The Super Bright Green source color devices are made z Popular T-1 diameter package. with Gallium Phosphide Green Light Emitting Diode. z General purpose leads. z Electrostatic discharge and power surge could damage z Reliable and rugged. the LEDs. z Long life - solid state reliability. z It is recommended to use a wrist band or anti- z Available on tape and reel. electrostatic glove when handling the LEDs. z 14V internal resistor. z All devices, equipments and machineries must be z RoHS compliant. electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAL0545 REV NO: V.5B DATE: JAN/23/2015 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101029218 Selection Guide Iv (mcd) 2 Viewing V= 14V Angle 1 Part No. Dice Lens Type Min. Typ. 21/2 WP710A10SGD14V Super Bright Green (GaP) Green Diffused 8 20 40 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. 3. Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. Units Test Conditions peak Peak Wavelength Super Bright Green 565 nm VF=14V D 1 Dominant Wavelength Super Bright Green 568 nm VF=14V 1/2 Spectral Line Half-width Super Bright Green 30 nm VF=14V IF Forward Current Super Bright Green 10.5 13.5 mA VF=14V IR Reverse Current Super Bright Green 10 uA VR = 5V Notes: 1. Wavelength: +/-1nm. 2. Wavelength value is traceable to the CIE127-2007 compliant national standards. 3. Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Absolute Maximum Ratings at TA=25C Parameter Super Bright Green Units Power dissipation 160 mW Forward Voltage 16 V Reverse Voltage 5 V Operating Temperature -40C To +70C Storage Temperature -40C To +85C Lead Solder Temperature 1 260C For 3 Seconds Lead Solder Temperature 2 260C For 5 Seconds Notes: 1. 2mm below package base. 2. 5mm below package base. SPEC NO: DSAL0545 REV NO: V.5B DATE: JAN/23/2015 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: P.Cheng ERP: 1101029218