WP710A10SRD/J4 Kingbright

T-1 (3mm) SOLID STATE LAMP Part Number: WP710A10SRD/J4 Super Bright Red Features Description z Low power consumption. The Super Bright Red source color devices are made with z Popular T-1 diameter package. AlGaInP on Si substrate Light Emitting Diode. z General purpose leads. z Reliable and rugged. z Long life - solid state reliability. z Available on tape and reel. z RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAM7525 REV NO: V.1A DATE: NOV/20/2012 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: D.M.Su ERP: 1101032240 Selection Guide Iv (mcd) 2 Viewing 20mA Angle 1 Part No. Dice Lens Type Min. Typ. 2 1/2 600 1500 WP710A10SRD/J4 Super Bright Red (AlGaInP) Red Diffused 40 *200 *500 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. *Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. Units Test Conditions peak Peak Wavelength Super Bright Red 660 nm IF=20mA D 1 Dominant Wavelength Super Bright Red 640 nm IF=20mA 1/2 Spectral Line Half-width Super Bright Red 20 nm IF=20mA C Capacitance Super Bright Red 45 pF VF=0V f=1MHz VF 2 Forward Voltage Super Bright Red 2.1 2.5 V IF=20mA IR Reverse Current Super Bright Red 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to the CIE127-2007 compliant national standards. Absolute Maximum Ratings at TA=25C Parameter Super Bright Red Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current 1 150 mA Reverse Voltage 5 V Operating/Storage Temperature -40C To +85C Lead Solder Temperature 2 260C For 3 Seconds Lead Solder Temperature 3 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAM7525 REV NO: V.1A DATE: NOV/20/2012 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: D.M.Su ERP: 1101032240