Thyristors Surface Mount 400V - 800V > MAC12D, MAC12M, MAC12N Pb MAC12D, MAC12M, MAC12N Description Designed for high performance fullwave ac control applications where high noise immunity and commutating di/dt are required. Features Blocking Voltage to 800 Volts OnState Current Rating of 12 Amperes RMS at 70C Uniform Gate Trigger Currents in Three Quadrants, Q1, Q2, and Q3 High Immunity to dv/dt 250 V/s Minimum at 125C Disclaimer Notice - Information furnished is believed to be accurate and reliable. However, users should independently evaluate the suitability of and High Commutating di/dt 6.5 A/ms Minimum at 125C test each product selected for their own applications. Littelfuse products are not designed for, and may not be used in, all applications. Read complete Disclaimer Notice at: www.littelfuse.com/disclaimer-electronics Pin Out Industry Standard TO220 Package Functional Diagram MT2 MT1 G CASE 221A STYLE 4 1 Additional Information 2 Samples Datasheet Resources 2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 08/30/17Thyristors Surface Mount 400V - 800V > MAC12D, MAC12M, MAC12N Maximum Ratings (T = 25C unless otherwise noted) J Rating Symbol Value Unit Peak Repetitive Off-State Voltage (Note 1) V , (Gate Open, Sine Wave 50 to 60 Hz, T = 25 to 100C) DRM J MAC12D 400 V V RRM MAC12M 600 MAC12N 800 On-State RMS Current (Full Cycle Sine Wave, 60 Hz, T = 70C) I 12 A C T (RMS) Peak Non-Repetitive Surge Current I 100 A TSM (One Full Cycle Sine Wave, 60 Hz, T = 125C) J 2 Circuit Fusing Consideration (t = 8.3 ms) I t 41 Asec Peak Gate Power P 16 W GM (Pulse Width 1.0 s, T = 80C) C Average Gate Power (t = 8.3 ms, T = 80C) P 0.35 W C G (AV) Operating Junction Temperature Range T -40 to +125 C J Storage Temperature Range T -40 to +150 C stg Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. 1. V and V for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage however, positive gate voltage shall not be applied concurrent with negative DRM RRM potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. Thermal Characteristics Rating Symbol Value Unit R Thermal Resistance, JunctiontoCase (AC) 2.2 8JC C/W JunctiontoAmbient 62.5 R 8JA Maximum Lead Temperature for Soldering Purposes, 1/8 from case for 260 C T L 10 seconds 2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 08/30/17