MDS-189-PIN

MD- / MDS-189 High Level Termination Insensitive Mixer, Rev. V4 1 - 3500 MHz Features FP-2 (MD-189) Operates Over Full PCN/PCS/PHS/MSS Bands Low Conversion Loss Fully Hermetic Package Intermodulation Ratio Insensitive to System Mismatches VSWR: <2.0:1 Typical Midband Isolation: 35 dB Typical Midband High IIP (+28 dBm Typical 1-3500 MHz) 3 Description M/A-COMs MD-189 and MDS-189 are high level termination insensitive mixers. These devices are packaged in 8-lead flatpack and SMT packages. These mixers offer consistent and repeatable flat intermodulation performance and flat conversion loss with low spurious signal generation independent of system mismatch from 1 to 3500 MHz. The MD -189 and MDS-189 are ideally suited for RF/IF com- munications applications requiring high intercept point performance. SF-1 (MDS-189) Pin Configuration (MD-189) Pin No. Function Pin No. Function 1 GND 5 LO 2 GND 6 GND 3 GND 7 GND 4 IF 8 RF Pin Configuration (MDS-189) Pin No. Function Pin No. Function 1 GND 3 LO 2 IF 4 RF 1 Absolute Maximum Ratings Parameter Absolute Maximum 2 o Max Input Power 0.5W Derated to 85 C o Total Power 3.2 mW/ C LO Power +27 dBm 1. Operation of this device above any one of these parameters nay cause permanent damage. o 2. Ambient Temperature (T ) = +25 C A 1 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: MD- / MDS-189 High Level Termination Insensitive Mixer, Rev. V4 1 - 3500 MHz 1 Electrical Specifications : T = -55C to +85C A Frequency: RF, LO Ports = 1-3500 MHz, IF Port = 5-1500 MHz Parameter Test Conditions Frequency Units Min Typ Max Conversion Loss LO 23 dBm 5 - 1000 MHz dB 6.5 7.0 IF 60 MHz 1000 - 3000 MHz dB 7.5 8.5 1 - 3500 MHz dB 8.0 9.5 Isolation LO to RF 1 - 2000 MHz dB 30 35 2000 - 3500 MHz dB 25 30 LO to IF 1 - 2000 MHz dB 25 30 2000 - 3500 MHz dB 20 25 RF to IF 10 - 500 MHz dB 30 35 1 - 3500 MHz dB 15 20 Input Compression LO 23 dBm +20 (1 dB) IF 60 MHz IIP LO 23 dBm dBm +28 3 IF 60 MHz Desensitivity (1dB) LO 23 dBm dBm +17 IF 60 MHz dBm SSB Noise Figure LO 23 dBm IF 60 MHz Within 1 dB of Conversion Loss Max Bottom View of SF-1 Typical Performance Curves 4X .016 .002 .506 .385 Ref .220 .381 .165 .002 .000 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: