24LC32AT-E/OT Microchip

24AA32A/24LC32A 2 32K I C Serial EEPROM Device Selection Table Description: Part VCC Max. Clock Temp. The Microchip Technology Inc. 24AA32A/24LC32A Number Range Frequency Ranges (24XX32A*) is a 32 Kbit Electrically Erasable PROM. The device is organized as a single block of 4K x 8-bit (1) 24AA32A 1.7-5.5 400 kHz I memory with a 2-wire serial interface. Low-voltage 24LC32A 2.5-5.5 400 kHz I, E design permits operation down to 1.7V, with standby Note 1: 100 kHz for VCC <2.5V. and active currents of only 1 A and 1 mA, respectively. It has been developed for advanced, low- power applications such as personal communications Features: or data acquisition. The 24XX32A also has a page write Single Supply with Operation down to 1.7V for capability for up to 32 bytes of data. Functional address 24AA32A Devices, 2.5V for 24LC32A Devices lines allow up to eight devices on the same bus, for up to 256 Kbits address space. The 24XX32A is available Low-Power CMOS Technology: in the standard 8-pin PDIP, surface mount SOIC, SOIJ, - Active current 1 mA, typical TSSOP, DFN, TDFN and MSOP packages. The - Standby current 1 A, typical 24XX32A is also available in the 5-lead SOT-23 and 2 2-Wire Serial Interface, I C Compatible Chip Scale packages. Schmitt Trigger Inputs for Noise Suppression Output Slope Control to Eliminate Ground Bounce Block Diagram 100 kHz and 400 kHz Clock Compatibility A0 A1 A2 WP HV Generator Page Write Time 5 ms max. Self-Timed Erase/Write Cycle 32-Byte Page Write Buffer I/O Memory EEPROM Control XDEC Hardware Write-Protect Control Array Logic Logic ESD Protection > 4,000V Page Latches More than 1 Million Erase/Write Cycles Data Retention > 200 Years I/O SCL Factory Programming Available YDEC Packages Include 8-lead PDIP, SOIC, SOIJ, SDA TSSOP, X-Rotated TSSOP, MSOP, DFN, TDFN, 5-lead SOT-23 and Chip Scale Vcc Sense Amp. Pb-Free and RoHS Compliant VSS R/W Control Temperature Ranges: - Industrial (I): -40C to +85C - Automotive (E): -40C to +125C Package Types PDIP/MSOP/SOIC/SOIJ/TSSOP (1) DFN/TDFN SOT-23 CS (Chip Scale) X-Rotated TSSOP SCL WP 1 5 1 A0 8 VCC A0 1 8 VCC (X/ST) VCC VSS 1 2 WP 2 7 A1 A1 2 7 WP VSS 1 8 2 WP SCL WP 3 6 SCL A2 3 2 7 VCC SDA A2 3 6 SCL SDA 45 SCL 6 3 VSS 4 5 A0 VSS SDA 34 VCC SDA 4 5 A1 A2 VSS 4 5 SDA (Top Down View, Balls Not Visible) Note 1: Available in I-temp, AA only. *24XX32A is used in this document as a generic part number for the 24AA32A/24LC32A devices. 2002-2012 Microchip Technology Inc. DS21713M-page 124AA32A/24LC32A 1.0 ELECTRICAL CHARACTERISTICS () Absolute Maximum Ratings VCC.............................................................................................................................................................................6.5V All inputs and outputs w.r.t. VSS ......................................................................................................... -0.3V to VCC +1.0V Storage temperature ...............................................................................................................................-65C to +150C Ambient temperature with power applied................................................................................................-40C to +125C ESD protection on all pins 4 kV NOTICE: Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at those or any other conditions above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for extended periods may affect device reliability. TABLE 1-1: DC CHARACTERISTICS Industrial (I): TA = -40C to +85C, VCC = +1.7V to +5.5V DC CHARACTERISTICS Automotive (E): TA = -40C to +125C, VCC = +2.5V to +5.5V Param. Symbol Characteristic Min. Typ. Max. Units Conditions No. D1 A0, A1, A2, WP, SCL and SDA pins D2 VIH High-level input voltage 0.7 VCC V D3 VIL Low-level input voltage 0.3 VCC V VCC 2.5V 0.2 VCC V VCC < 2.5V D4 VHYS Hysteresis of Schmitt 0.05 VCC V VCC 2.5V (Note 1) Trigger inputs (SDA, SCL pins) D5 VOL Low-level output voltage 0.40 V IOL = 3.0 mA, VCC = 4.5V IOL = 2.1 mA, Vcc = 2.5V D6 ILI Input leakage current 1 AVIN = VSS or VCC D7 ILO Output leakage current 1 AVOUT = VSS or VCC D8 CIN, Pin capacitance 10 pFVCC = 5.0V (Note 1) COUT (all inputs/outputs) TA = 25C, FCLK = 1 MHz D9 ICC write Operating current 0.1 3 mAVCC = 5.5V, SCL = 400 kHz D10 ICC read 0.05 400 A CCS Standby current 0.01 1 A Industrial D11 I 5 A Automotive SDA = SCL = VCC = 5.5V A0, A1, A2, WP = VSS Note 1: This parameter is periodically sampled and not 100% tested. 2: Typical measurements taken at room temperature. DS21713M-page 2 2002-2012 Microchip Technology Inc.