AT90USB1286-AUR Microchip

Features High performance, low power AVR 8-bit Microcontroller Advanced RISC architecture 135 powerful instructions most single clock cycle execution 32 8 general purpose working registers Fully static operation Up to 16MIPS throughput at 16MHz On-chip 2-cycle multiplier Non-volatile program and data memories 8-bit Atmel 64/128Kbytes of in-system self-programmable flash Endurance: 100,000 write/erase cycles Microcontroller Optional Boot Code section with independent lock bits USB boot loader programmed by default in the factory with In-system programming by on-chip boot program hardware activated after reset 64/128Kbytes True read-while-write operation All supplied parts are pre-programed with a default USB bootloader of ISP Flash 2K/4K (64K/128K flash version) bytes EEPROM Endurance: 100,000 write/erase cycles and USB 4K/8K (64K/128K flash version) bytes internal SRAM Controller Up to 64Kbytes optional external memory space Programming lock for software security JTAG (IEEE std. 1149.1 compliant) interface Boundary-scan capabilities according to the JTAG standard AT90USB646 Extensive on-chip debug support Programming of flash, EEPROM, fuses, and lock bits through the JTAG interface AT90USB647 USB 2.0 full-speed/low-speed device and on-the-go module Complies fully with: AT90USB1286 Universal serial bus specification REV 2.0 AT90USB1287 On-the-go supplement to the USB 2.0 specification rev 1.0 Supports data transfer rates up to 12Mbit/s and 1.5Mbit/s USB full-speed/low speed device module with interrupt on transfer completion Endpoint 0 for control transfers: up to 64-bytes Six programmable endpoints with in or out directions and with bulk, interrupt or isochronous transfers Configurable endpoints size up to 256bytes in double bank mode Fully independent 832bytes USB DPRAM for endpoint memory allocation Suspend/resume interrupts Power-on reset and USB bus reset 48MHz PLL for full-speed bus operation USB bus disconnection on microcontroller request USB OTG reduced host: Supports host negotiation protocol (HNP) and session request protocol (SRP) for OTG dual-role devices Provide status and control signals for software implementation of HNP and SRP Provides programmable times required for HNP and SRP Peripheral features Two 8-bit timer/counters with separate prescaler and compare mode Two16-bit timer/counter with separate prescaler, compare- and capture mode 7593LAVR09/12 Real time counter with separate oscillator Four 8-bit PWM channels Six PWM channels with programmable resolution from 2 to 16 bits Output compare modulator 8-channels, 10-bit ADC Programmable serial USART Master/slave SPI serial interface Byte oriented 2-wire serial interface Programmable watchdog timer with separate on-chip oscillator On-chip analog comparator Interrupt and wake-up on pin change Special microcontroller features Power-on reset and programmable brown-out detection Internal calibrated oscillator External and internal interrupt sources Six sleep modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and Extended Standby I/O and packages 48 programmable I/O lines 64-lead TQFP and 64-lead QFN Operating voltages 2.7 - 5.5V Operating temperature Industrial (-40C to +85C) Maximum frequency 8MHz at 2.7V - industrial range 16MHz at 4.5V - industrial range 2 AT90USB64/128 7593LAVR09/12