MIC5370/1 High-Performance Dual 150mA LDO 1.6mm x 1.6mm Thin MLF General Description Features The MIC5370/1 is an advanced dual LDO ideal for 2.5V to 5.5V input voltage range powering general purpose portable devices. The Two 150mA output current LDOs MIC5370/1 provides two independently-controlled, high- High output accuracy performance 150mA LDOs in a tiny 1.6mm x 1.6mm Thin 2% initial accuracy MLF package. Low quiescent current 32A per LDO Ideal for battery-powered applications, the MIC5370/1 Stable with 1F ceramic output capacitors offers 2% initial accuracy, low dropout voltage (155mV 150mA) and low ground current (typically 32A per LDO). Independent enable pins The MIC5370/1 can also be put into a zero-off-mode Low dropout voltage 155mV at 150mA current state, drawing virtually no current when disabled. Thermal-shutdown protection When the MIC5371 is disabled an internal resistive load is Current-limit protection automatically applied to the output to discharge the output Output discharge circuit MIC5371 capacitor. This LDO offers fast transient response and high PSRR while consuming a minimum operating current. 6-pin 1.6mm x 1.6mm Thin MLF package The MIC5370/1 is available in fixed output voltages in a lead-free (RoHS-compliant) 6-pin 1.6mm x 1.6mm Thin Applications MLF package. Camera phones Data sheets and support documentation can be found on Mobile phones Micrels web site at: www.micrel.com. GPS, PMP, PDAs and handhelds Portable electronics Typical Application MIC5370/1-xxYMT I/O VIN VOUT1 VCORE EN1 VOUT2 1F 1F 1F VBAT EN2 GND Camera DSP Power Supply Circuit MLF and MicroLeadFrame are registered trademarks of Amkor Technology, Inc. Micrel Inc. 2180 Fortune Drive San Jose, CA 95131 USA tel +1 (408) 944-0800 fax + 1 (408) 474-1000 Micrel, Inc. MIC5370/1 Block Diagrams VOUT1 VIN LDO1 VOUT2 LDO2 EN1 ENABLE EN2 REFERENCE GND MIC5370 Block Diagram VIN VOUT1 LDO1 VOUT2 LDO2 EN1 ENABLE EN2 AUTO DISCHARGE REFERENCE GND MIC5371 Block Diagram M9999-052011-C May 2011 2