6DOF IMU 5 Click PID: MIKROE-4089 6DOF IMU 5 Click features 7-Axis ICM-20789 chip from TDK, an integrated 6-axis inertial device that combines a 3-axis gyroscope, 3-axis accelerometer, and an ultra-low noise MEMS capacitive pressure sensor. This unique 7-Axis device offers great performance with an accuracy of 1 Pa, an accuracy enabling altitude measurement differentials as small as 8.5 cm. The pressure sensors MEMS capacitive architecture provides the industrys lowest noise at the lowest power, high sensor throughput, and temperature coefficient offset of 0.5 Pa/C. The combination of high accuracy elevation measurements, low power, and temperature stability makes it ideal for a wide range of motion tracking applications. 6DOF IMU 5 Click is supported by a mikroSDK compliant library, which includes functions that simplify software development. This Click board comes as a fully tested product, ready to be used on a system equipped with the mikroBUS socket. Specifications Type Acceleration,Gyroscope,Motion,Pressure Applications Drones and Flying Toys, Motion-based gaming controllers, Virtual Reality Headsets & Controllers, Indoor/Outdoor Navigation (dead- reckoning, floor/elevation/step detection) On-board modules 6DOF IMU 5 Click uses the ICM-20789 IC, a 6-axis inertial sensor, from TDK InvenSense Key Features Pressure operating range: 30 to 110 kPa, Pressure Sensor Relative Accuracy: 1 Pa, Gyroscope programmable FSR, Accelerometer with Programmable FSR and many more Interface I2C,SPI Compatibility mikroBUS Click board size M (42.9 x 25.4 mm) Input Voltage 3.3V Resources mikroBUS mikroSDK Click board Catalog Click boards Downloads 6DOF IMU 5 click example on Libstock 6DOF IMU 5 click 2D and 3D files ICM-20789 datasheet 6DOF IMU 5 click schematic Powered by TCPDF (www.tcpdf.org)