NFZ2MSD501SZ10L Murata

Reference Only Spec No.JETE243A-9103B-01 P 1/9 CHIP NOISE FILTER NFZ2MSDSZ10L REFERENCE SPECIFICATION Murata Standard SpecificationAEC-Q200 1. Scope This reference specification applies to NFZ2MSD SZ10L, Chip Noise Filter for Automotive Electronic based on AEC-Q200.except for Power train and Safety 2.Part Numbering (ex) NF Z 2M SD 101 S Z 1 0 L Numbers Special Product Typical Structure Dimension Characteristics Performance Category Of Speci- Packaging ID Impedance Circuit fication (LW) at 100MHz (T) L: 180Taping 3.Rating Operating Temperature Range (Ambient temperature Self-temperature rise is not included) -40 to +85C (Product temperature Self- temperature rise is included) -40 to +125C Storage Temperature Range. -40 to +85C Withstand voltage 20V Impedance Impedance DC Resistance ESD *1 Rated Current Customer Murata at 10MH at 100MH Max Rank Part Number Part Number A:0.5kV () Tolerance Typ () (m ) A NFZ2MSD101SZ10L 9 100 18 5.2 A NFZ2MSD181SZ10L 15 180 22 4.0 A NFZ2MSD301SZ10L 21 30% 300 26 3.8 A NFZ2MSD501SZ10L 29 500 32 3.2 A NFZ2MSD102SZ10L 46 1000 46 2.5 A *1: When applied Rated current to the Products, self temperature rise shall be limited to 40 max. 4. Testing Conditions (Standard atmospheric conditions) <Unless otherwise specified> <In case of doubt> Temperature : Ordinary Temperature (15 to 35C) Temperature : 20 2C Humidity : Ordinary Humidity (25 to 85 %(RH)) Humidity : 60 to 70 %(RH) Atmospheric Pressure : 86 to 106 kPa 5.Appearance and Dimensions no marking (in mm) Unit Mass (Typical value) 0.0188g MURATA MFG.CO., LTD Reference Only Spec No.JETE243A-9103B-01 P 2/9 6. Electrical Performance No. No. Item Specification 6.1 Impedance Meet item 3. Measuring Equipment: KEYSIGHT 4287A or equivalent (0.5V) Measuring Frequency: 10MHz 6.2 DC Resistance Measuring Equipment: Digital multi meter 7. Q200 Requirement AEC-Q200 Rev.D issued June 1. 2010 AEC-Q200 Murata Specification / Deviation No.Stress Test Method 3 High 1000hours at 125 deg C Meet Table A after testing. Temperature Set for 24hours Table A Exposure at room temperature, Appearance No damage then measured. Impedance Change Within 30% (at 10MHz) 4 Temperature Cycling 1000cycles -40 deg C to +125 deg C Set for 24hours at room temperature, then measured. Not Applicable 5 Destructive Per EIA469 Physical Analysis No electrical tests 7 Biased Humidity 1000hours at 85 deg C, 85%RH Meet Table A after testing. MURATA MFG.CO., LTD