RoHS Compliance This component is compliant with RoHS directive. This component was always RoHS compliant from the first date of manufacture. SF2433D High Performance SAW Filter 3.8 x 3.8 mm Surface-mount Package 500 MHz Absolute Maximum Ratings SAW Filter Rating Value Units Maximum Incident Power in Passband +10 dBm Maximum DC Voltage Between any Two Active Terminals 3 VDC Operable Temperature Range -45 to +125 C -40 to +85 C Specification Temperature Range Storage Temperature Range -40 to +85 C Suitable for Lead-free Soldering - Maximum Soldering Profile 260 C for 20 - 40 sec SM3838-8 Electrical Characteristics Characteristic Sym Notes Min Typ Max Units Center Frequency f 500 MHz C Insertion Loss ILmin 2.2 2.8 dB 2 dB Bandwidth BW 20 24 MHz -2dB Rejection referenced to IL at Peak : 400 to 455 MHz 40 55 514 to 535 MHz (-25 to +55C) 5 10 dB 545 to 555 MHz 30 55 555 to 600 MHz 40 55 Temperature Coefficient of Frequency -36 ppm/C Case Style 3.8 x 3.8 mm Nominal Footprint Lid Symbolization, Y=year, WW=week, S=shift, Dot=pin 1 indicator B43, YWWS Electrical Connections Connection Terminals Input 2 Output 6 1 8 7 Case Ground All others 50 50 2 6 3 4 5 CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. NOTES: 1. Unless noted otherwise, all specifications apply over the operating tem- 4.LRI or after the part number indicateslow rate initial productio perature range with filter soldered to the specified demonstration board andEN or indicatesengineering prototypes with impedance matching to 50 and measured with 50 network ana- 5. The design, manufacturing process, and specifications of this filter are lyzer. subject to change. 2. Unless noted otherwise, all frequency specifications are referenced to the 6. Either Port 1 or Port 2 may be used for either input or output in the design. nominal center frequency, fc. However, impedances and impedance matching may vary between Port 1 3. Rejection is measured as attenuation below the minimum IL point in the and Port 2, so that the filter must always be installed in one direction per passband. Rejection in final user application is dependent on PCB layout the circuit design. and external impedance matching design. See Application Note No. 42 7. US and international patents may apply. for details. 8. Murata, stylized Murata logo, and Murata N.A., Inc. are registered trademarks of Murata Manufacturing Co., Ltd. Copyright Murata Manufacturing Co., Ltd. All rights reserved. 2016 SF2433D 3/6/19 Page 1 of 4 www.murata.comFrequency Characteristics Span: 200 MHz Span: 100 MHz Copyright Murata Manufacturing Co., Ltd. All rights reserved. July 2016 SF2433D 3/6/19 Page 2 of 4 www.murata.com