CTU-M2R Netronix

Technical Data Sheet RFID reader CTU-M series CTU-Mxx-man-eng-v2.pdf Fig. 1 CTU-M2R ATTENTION THIS CONFIDENTIAL DOCUMENT IS PROPERTY OF NETRONIX SP. Z O.O. DISTRIBUTION OF THIS DOCUMENT IN ANY WAY WITHOUT SPECIAL PERMISSION OF ITS OWNER IS STRICTLY FORBIDDEN1. INTRODUCTION ............................................................................................. 5 2. GENERAL SPECIFICATION........................................................................... 6 3. DIMENSION, TERMINAL DESCRIPTION....................................................... 7 4. MODULE SETTINGS BY ON-BOARD SWITCH............................................. 8 5. TRANSMISSION PROTOCOLS...................................................................... 8 5.1. RS-232/485 TRANSMISSION PROTOCOL ................................................ 8 2 5.2. Protocol for I C transmission............................................................................. 8 5.2.1. Data exchange algorithm ............................................................................... 8 5.2.2. Timings............................................................................................................ 10 5.3. Protocol for 1WIRE (Dallas) bus...................................................................... 10 5.4. Wiegand protocol ................................................................................................ 12 5.5. Key management................................................................................................. 13 5.5.1. Key loading into dynamic key memory....................................................... 13 5.5.2. Key loading to key static memory ............................................................... 14 5.6. Commands for communication with transponder ..................................... 14 5.6.1. On/off switching of reader field.................................................................... 14 5.6.2. Selecting one of many transponders.......................................................... 15 5.6.3. Logging by means of Dynamic Key Buffer to selected sector of transponder......................................................................................................................... 16 5.6.4. Logging by means of Static Key Buffer to selected sector of transponder......................................................................................................................... 16 5.6.5. Reading-out the content of transponder block.......................................... 17 5.6.6. Writing the content of transponder block ................................................... 17 5.6.7. Copying the content of transponder block into other block..................... 18 5.6.8. Writing the page content into Mifare UL .................................................... 18 5.6.9. Reading the page content in Mifare UL ..................................................... 19 5.6.10. Writing values to transponder block ....................................................... 19 5.6.11. Reading-out the values from transponder block................................... 20 5.6.12. Increasing the value included in transponder block............................. 20 5.6.13. Decreasing the value included in block transponder ........................... 21 5.6.14. Setting the transponder in field into sleep mode .................................. 21 5.7. Reader inputs and outputs ............................................................................... 22 5.7.1. Writing the output state................................................................................. 22 5.7.2. Reading the input state................................................................................. 22 5.7.3. Writing the settings to any port.................................................................... 23